Abstract:OBJECTIVES:In this paper, we present a unified electrodynamic heart model that permits simulations of the body surface potentials generated by the heart in motion. The inclusion of motion in the heart model significantly improves the accuracy of the simulated body surface potentials and therefore also the 12-lead ECG.METHODS:The key step is to construct an electromechanical heart model. The cardiac excitation propagation is simulated by an electrical heart model, and the resulting cardiac active forces are used to calculate the ventricular wall motion based on a mechanical model. The source-field point relative position changes during heart systole and diastole. These can be obtained, and then used to calculate body surface ECG based on the electrical heart-torso model.RESULTS:An electromechanical biventricular heart model is constructed and a standard 12-lead ECG is simulated. Compared with a simulated ECG based on the static electrical heart model, the simulated ECG based on the dynamic heart model is more accordant with a clinically recorded ECG, especially for the ST segment and T wave of a V1-V6 lead ECG. For slight-degree myocardial ischemia ECG simulation, the ST segment and T wave changes can be observed from the simulated ECG based on a dynamic heart model, while the ST segment and T wave of simulated ECG based on a static heart model is almost unchanged when compared with a normal ECG.CONCLUSIONS:This study confirms the importance of the mechanical factor in the ECG simulation. The dynamic heart model could provide more accurate ECG simulation, especially for myocardial ischemia or infarction simulation, since the main ECG changes occur at the ST segment and T wave, which correspond with cardiac systole and diastole phases.

Optimization of Electrode Location and Size on Simulation in Electric Field Distribution of Atrial Deifbrillation

[Optimization of Electrode Location and Size on Simulation in Electric Field Distribution of Atrial Defibrillation].

Current Progress of Computational Modeling for Guiding Clinical Atrial Fibrillation Ablation.

Preliminary Simulation Study of Atrial Fibrillation Treatment Procedure Based on A Detailed Human Atrial Model

Simulation Study of Heart Defibrillation Based on Finite Element Method

Potential Maintenance Mechanism in Atrial Fibrillation Patients Subject to Different Treatment Procedures: A Preliminary Study Based on a Human Atrial Model

Study the Effect of Tissue Heterogeneity and Anisotropy in Atrial Fibrillation Based on a Human Atrial Model

Electrodynamic Heart Model Construction and ECG Simulation

Beating Heart Modeling and Simulation

Towards the Cardiac Equivalent Source Models in Electrocardiography and Magnetocardiography: A Simulation Study

Simulation of Non-Transmural Ablation Lines That Effectively Block Electrical Signal Propagation in the Heart

THE CONSTRUCTION OF THE ELECTROCARDIOGRAPHIC SIMULATION MODEL OF BEATING HEART

Simulation Study of A Magnetocardiogram Based on A Virtual Heart Model: Effect of A Cardiac Equivalent Source and A Volume Conductor

Parallel Solution In Simulation Of Cardiac Excitation Anisotropic Propagation

Simulation study of biatrial conduction via different conduction path-ways in atrial fibrillation

Optimization of Electrodes Displacement for Transthoracic Defibrillation: A Simulation Study on Spatial Configuration Pattern

A Mono-bidomain Electrophysiological Simulation Method for Electrical Defibrillation Research

Low-energy Defibrillation with Multi-Electrodes Stimulation: A Simulation Study.

A Study of Mechanical Optimization Strategy for Cardiac Resynchronization Therapy Based on an Electromechanical Model

Low-energy Defibrillation Research Using a Rabbit Ventricular Model: Optimizing the Potential Gradient Distribution Using Multiple Epicardial Electrodes.

The Effect of Discharge Mode on the Distribution of Myocardial Pulsed Electric Field-A Simulation Study for Pulsed Field Ablation of Atrial Fibrillation