Abstract:Background: Aerosol delivery via high-flow nasal cannula (HFNC) has gained popularity due to the increased use of the modality for treating hypoxemic and hypercapnic respiratory failure. Various HFNC devices are available in the United States; however, the effectiveness of aerosol delivery via HFNC devices remains unclear. Thus, this study aimed to investigate the impact of various commercially available devices on transnasal aerosol delivery. Methods: This was a bench study that used a 2-chamber lung model, in which one chamber was connected to an adult manikin with anatomically correct upper-airway proportions. The other chamber was connected to a critical care ventilator used to simulate spontaneous breathing. A size large nasal cannula was placed at the nasal opening of the manikin. Five different HFNC devices (Hamilton-C1, OptiFlow, Airvo2, V60 Plus, and Vapotherm) were compared. Four flow settings were used on each device, with a vibrating mesh nebulizer placed at the humidifier. Salbutamol (2.5 mg/3 mL) was used during the experiments to quantify inhaled drug doses. A collection filter was placed between the manikin's trachea and the lung model. The drug was eluted from the filter and assayed with ultraviolet spectrophotometry (276 nm). Results: Among the 5 HFNC devices, OptiFlow had the highest inhaled dose at 10 L/min (mean ± SD 18.2% ± 1.2%). At 20 L/min, the Hamilton-C1 (mean ± SD 13.5% ± 0.4%) performed marginally better than the OptiFlow (mean ± SD 12.6% ± 1.9%) and Airvo2 (mean ± SD 12.8% ± 1%). At high flow settings (40-60 L/min), the inhaled dose of Hamilton-C1 was 2-3 times that of the Airvo2 and V60 Plus. When compared with the other devices, the mean inhaled dose with the Vapotherm was lower (0.9-2.5%). In all devices, the inhaled dose decreased as the flow increased. Conclusions: Transnasal aerosol delivery was significantly impacted by the types of HFNC devices and flow settings. Nominal doses might need to be adjusted if changing HFNC devices or flow is not an option.

The Factors Influencing the Air-extraction Successful Rate During Venous Infusion

Optimization of Venous Return Tubing Diameter for Cardiopulmonary Bypass.

Numerical Comparison of the Efficiency of Mixing Ventilation and Impinging Jet Ventilation for Exhaled Particle Removal in a Model Intensive Care Unit

Effects of Tube Size for Drainage on Flow Rate of Different Kinds of Fluid Studied in Vitro

The Inferior Vena Cava Filter Placement Parameters May Predict Filter Retrieval Outcomes

Control Volume Analysis of the Infusion Rate in Cephalic and Median Cubital Veins Based on Infusion Bag Height and Peripheral Venous Catheter Inner Diameter: Application of Bernoulli's Equation and Consideration of Frictional Forces

The Value of High-Flow Nasal Cannula Oxygen Therapy after Extubation in Patients with Acute Respiratory Failure.

Comparison of Fluid Flow Rates by Fluid Height and Catheter Size in Normal and Hypertensive Blood-Pressure Scenarios

Examination of Particulate Contamination in Parenteral Injections and Infusions Following Fluid Withdrawal Utilizing Conventional Needles and Filter Needles: Assessment of Compliance and Comparative Analysis

Study on the blood flow characteristics of venous needle retention with different super-hydrophobic surface structures

The Impact of Various High-Flow Nasal Cannula Devices on Transnasal Aerosol Delivery

Effect of Open-Ended Venous Port with Different Sealing Fluids to Seal Tube

The clinic nursing research of the choice of the method of venous puncture and the success rate of puncture

Numerical Investigation of Impinging Jet Ventilation in ICUs: is Thermal Stratification a Problem?

Comprehensive evaluations of the bioaerosol filtration performance of high- and medium-efficiency filters under different influencing factors

Effect of central venous pressure on fluid delivery during start-up of syringe infusion pumps for microinfusion

Meta-analysis of intravenous infusion by reverse puncture on dorsal surface of metacarpophalangeal joints

Size-Dependent Removal Efficiency of Mechanical Ventilation System with Air Filtration Unit for Nanoparticles

Application and Experience of Permanent Needle of Deep Venipuncture in Intensive Care Unit of 1000 Cases

Assessment on methods and effects of 2131 integrated training of venipuncture skills for new nurses

Performance evaluation of high-volume evacuation for removing droplets during dental treatment