Influence of Cross-Section Design and Vertical Misfit on Stress Distribution in Overdenture Retaining System: 3-Dimensional Finite Element Analysis
Moises C F Nogueira,Atais Bacchi,Marcelo F Mesquita,Mateus B F Santos,Rafael L X Consani,Nogueira, Moises C. F.,Mesquita, Marcelo F.,Consani, Rafael L. X.,Bacchi, Atais,Santos, Mateus B. F.
DOI: https://doi.org/10.1097/ID.0000000000000770
2019-10-03
Implant Dentistry
Abstract:Purpose:
To evaluate by 3-dimensional (3-D) finite element analysis the stress generated on overdenture-retaining bar system with different cross sections (round, ovoid, or Hader) and misfit levels (50, 100, and 200 μm) manufactured with different metallic alloys (Au type IV, Ag-Pd, Ti cp, and Co-Cr).
Materials and Methods:
Three-dimensional finite element models were modeled using specific 3-D software (SolidWorks) and imported into mechanical simulation software (ANSYS). A displacement simulating the settlement of the screw was performed until the infrastructure was settled properly on the prosthetic platform.
Results:
Higher misfit levels caused higher stress on the overdenture-retaining bar system components, where (1) Hader bar presented the highest values (bar = 730.71; screw = 59.66, and periimplant bone tissue = 42.96, in megapascal) and (2) round bars made with type IV Au alloy presented lower stress values on the bar framework (193.99 MPa) and screw (10.27 MPa).
Conclusions:
Higher vertical misfit increased the stress values on the overdenture-retaining bar system; complex cross-sectional designs increased stress values on the bar framework, prosthetic screw, and periimplant bone tissue; stiffer alloys caused higher stress values on all the studied conditions.
dentistry, oral surgery & medicine