Abstract:A two-dimensional ultra performance liquid chromatography-quadrupole/time-of-flight mass spectrometry （2D-UPLC-Q/TOF-MS） method was established for the separation and structural analysis of the components in teicoplanin. This method effectively solved the problems associated with chromatographic systems， such as liquid chromatography-mass spectrometry （LC-MS）， which used a non-volatile phosphate buffer as the mobile phase and were not suitable for the rapid identification of impurities. Moreover， this method circumvented the complexities associated with locating and identifying impurities using the original method by re-establishing a chromatographic system suitable for LC-MS. In this study， for one-dimensional （1D） chromatography， the chromatographic separation was performed on an Octadecyl silica （ODS） hypersil column （250 mm×4.6 mm， 5 μm） with gradient elution using 3.0 g/L sodium dihydrogen phosphate buffer （pH 6.0）/acetonitrile=9/1 （v/v） as mobile phase A and 3.0 g/L sodium dihydrogen phosphate buffer （pH 6.0）/acetonitrile=3/7 （v/v） as mobile phase B. The column temperature was maintained at 30 ℃ and an ultraviolet detector was used at 254 nm for analysis. For 2D chromatography， desalting was performed on a Waters ACQUITY UPLC BEH C18 column （50 mm×2.1 mm， 1.7 μm） with gradient elution using ammonium formate buffer （pH 6.0） and acetonitrile as the mobile phases. The column temperature was maintained at 45 ℃. The MS data for the components and impurities were collected by positive ion electrospray ionization （ESI） using the full-information tandem MS mode （MSE）. The cone and nebulizer gas flow rates were set at 50 and 900 L/h， respectively. The ion source and nebulizer gas temperatures were set at 120 ℃ and 500 ℃， respectively. The ESI and cone needle voltages were set at 2500 and 60 V， respectively. The collision energy was set at 20-50 eV. The molecular formulas of the components and impurities were determined using their exact masses and isotope distributions， and the structural components and impurities of teicoplanin were deduced from their fragment ions according to the fragmentation pathway of the TA2-2 component. Moreover， the 10 components reported in the European Pharmacopoeia 10.0 were analyzed and 22 impurities of teicoplanin were identified by 2D-UPLC-Q/TOF-MS. Three new impurities and two characteristic fragment ions of the teicoplanin parent nucleus were detected， and the fragmentation pathway of TA2-2 was deduced. Using this method， 1D-UPLC is applicable for the accurate qualification of components based on relative retention times， and 2D-UPLC-Q/TOF-MS is suitable for the rapid identification of the structure of components based on their fragment ions. The results indicate that 2D-UPLC-Q/TOF-MS may be used to analyze the structure of impurities in teicoplanin based on their exact masses， isotope distributions， and fragment ions. The method is rapid， simple， and sensitive， which provides a novel strategy for the quality control and process optimization of teicoplanin.

Identification of the related substances in ceftazidime for injection by LC-MS techniques

Impurity Profile and Spectrum Characteristics of the Isomers in Cefamandole Nafate Using High- Performance Liquid Chromatography/high-Performance Size Exclusion Chromatography Tandem Ion Trap/time-of-flight Mass Spectrometry

Separation and Characterization of the Polymerized Impurities in Oxacillin Sodium by 2D HPSEC and HPLC IT-TOF MS

Separation and characterization of unknown impurities in cefonicid Sodium by trap-free two-dimensional liquid chromatography combined with ion trap/time-of-flight mass spectrometry.

Determination of the Related Substances in Anastrozole by Improving HPLC

[HPLC Determination of Zolmitriptan and Its Related Substances].

Determination of ceftizoxime in ceftizoxime sodium for injection / sodium chloride injection by high performance liquid chromatography

HPLC Determination of Cefpirome Sulfate and Its Related Substances in Cefpirome Sulfate for Injection

Effect of modification of oxide layer on NiTi stent corrosion resistance.

Impurity profiling of Cefteram pivoxil based on Fourier transform ion cyclotron resonance MS

ANALYSIS OF SEVERAL RESIDUAL SOLVENTS IN CEFTAZIDINE BY CAPILLARY GAS CHROMATOGRAPHY

Application of high-performance liquid chromatography hyphenated techniques for identification of degradation products of cefpodoxime proxetil

Screening and Identification of Multiple Components in Tanreqing Injection Using RP-HPLC Combined with DAD and ESI-TOF/MS

Pharmacokinetic study and rapid determination of ceftazidime in serum and urine with column packed by 3μm particle

A high-performance thin-layer chromatography densitometric method for the separation of isomeric ceftriaxone in powder for injection formulation

Determination of the Related Substances of Cetilistat by HPLC

Simultaneous Determination of Related Substances in Entecavir Film-Coated Tablet by High Performance Liquid Chromatography.

[Analysis of teicoplanin impurities by two-dimensional ultra performance liquid chromatography-quadrupole/time-of-flight mass spectrometry]

Studies on determination method for the related substances of Terfenadine tablets

Development of Thin-Layer Chromatography–Densitometric Procedure for Qualitative and Quantitative Analyses and Stability Studies of Cefazolin

Characterization of Elvitegravir and Its Related Impurities Using ESI–LC–MS, NMR Techniques, Method Development and Validation of Its Related Substances by HPLC Method