Cfd Simulation To The Flow Field Of Venturi Injector
Xingfa Huang,Guangyong Li,Miao Wang
DOI: https://doi.org/10.1007/978-1-4419-0211-5_3
2009-01-01
Abstract:Venturi injector is widely used in fertigation system due to its obvious advantages such as cheap and robust system without mobile pieces, simple structure, convenient to operation, stable performance, needless of external energy for operation etc. At present, the hydraulic parameters such as suction capacity (injection rate) for the most of the Venturi injectors produced domestically are not very desirable. In this paper, CFD (Computational Fluid Dynamics) method was used to simulate the inner flow field of the Venturi injectors, and the relationships among the structure parameters (i.e., throat length L, throat diameter D, slot diameter Da) and suction capacity q, and the optimal structure sizes of the Venturi injector were analyzed. The results show that when the inlet pressure and the slot position are kept unchanged as the sample one, the suction capacity of Venturi injector increases with the decrease of throat diameter D and throat length L, and the increase of slot diameter Da; while keeping the slot diameter Da, throat diameter D and throat length L unchanged, the suction capacity of Venturi injector q increases with the increase of inlet pressure P. The optimal combination of the structural parameters in this size was selected as follows: throat diameter D=8mm, slot diameter Da=18.5mm, and throat length L=14mm. In this case, the suction capacity of the Venturi injector q=1.203m3/h. The results can provide theoretic support for domestic Venturi injector research, design and manufacturing.