Abstract:Cavitation is a complex multiphase phenomenon characterised by vapour bubbles forming due to a sudden pressure drop and is often accompanied by increased hull vibrations, increased radiated noise and decrease in propeller and impeller performance. Although the Reynolds-Averaged Navier-Stokes (RANS) method coupled with a cavitation model is still considered a practical tool to predict cavitating flows owing to its computational efficiency, it is unable to predict the unsteadiness of vapor shedding and over-predicts the eddy viscosity. To improve the prediction, an empirical eddy viscosity correction,[Reboud et al. 1998] was proposed to consider the compressibility effects produced by cavitation. Additionally, a new type of models termed as hybrid RANS-Large Eddy Simulation (LES) models have also been recently introduced in the community, having the ability to behave as a RANS or a LES model in different regions of the flow in order to combine the computational cost efficiency of RANS with the accuracy of LES modelling. However, there exists a lack of a comprehensive review of various such turbulence models like the k-{\omega} Shear Stress Transport Model (SST), k-{\omega} SST Scale-adaptive Simulation (SAS), k-{\omega} SST Detached Eddy Simulation (DES), k-{\omega} SST Delayed DES (DDES), Filter-Based Method (FBM) and Partially-Averaged Navier Stokes Method (PANS) to predict cavitating flows. In this work, we conduct such a review to compare their ability to predict cloud cavitating flows by comparing them with x-ray experimental data in a venturi. It is shown that with mesh refinement, standard models do show the vapor unsteadiness as seen in the experiment similar to that seen when using the Reboud correction. However, on local comparison of turbulence quantities, it is observed both forms of models have huge discrepancies with experimental data that does not improve downstream.

Comparative Investigation among Three Cavitation Models for Simulating Cavitating Venturi

Numerical Simulation of Cavitating Flow in Water Hydraulic Axial Piston Pump

NUMERICAL INVESTIGATION OF THE VENTILATED CAVITATING FLOW AROUND AN UNDER-WATER VEHICLE BASED ON A THREE-COMPONENT CAVITATION MODEL

A Three-Component Model Suitable for Natural and Ventilated Cavitation

The Numerical Simulation of Cavitation Phenomenon in a Venturi Tube

Numerical Investigation of the Cavitation Characteristics in Venturi Tubes: The Role of Converging and Diverging Sections

A comparative evaluation of turbulence models for simulation of unsteady cavitating flows

CFD Turbulence Models Assessment for the Cavitation Phenomenon in a Rectangular Profile Venturi Tube

Numerical Analysis of Flow and Cavitation Characteristics in a Pilot-Control Globe Valve with Different Valve Core Displacements

Experimental and Numerical Investigation on the Cavity Regime and Drag Reduction of Ventilated Partial Cavity

Cavitation model with non-condensable gas effect and its numerical simulation

Modeling and Scaling of Cavitation Compliance in Venturi

Numerical Simulation of the Cavitation Characteristics of A Mixed-Flow Pump

Numerical Investigation of the Non-Condensable Gas Effect on Predicting the Cavitation Performance of a Centrifugal Pump

Numerical Analyses of Ventilated Cavitation over a 2-D NACA0015 Hydrofoil Using Two Turbulence Modeling Methods

Numerical Study on Flow Characteristics of Rotor Pumps Including Cavitation

CAVITATION MODEL VERIFICATION AND VALIDATION FOR WATER AND LIQUID NITROGEN IN AN INDUCER

Experiment and Numerical Simulation of Cavitation Performance for a Double Suction Centrifugal Pump

Investigation of the cavitation model in an inducer for water and liquid nitrogen

Cavitation Evolution Around a NACA0015 Hydrofoil with Different Cavitation Models Based on Level Set Method

Numerical investigation of ventilated cavitating flow from high to low cavitation numbers