Abstract:With the continuous development of network communication technology, the domestic network has covered the homes of ordinary people, but the indoor coverage system of the network cable network needs to be further improved. The optical fiber distribution system is a signal coverage system integrating GSM, TD-SCDMA, and other standards. It is mainly composed of system access unit, system expansion unit, and system remote unit. Wireless network is an important communication technology, which is easy to use and can be connected wirelessly over long distances. The purpose of this paper is to study an optical fiber distribution system for indoor coverage design of wireless networks, so as to achieve faster and more efficient coverage. In this paper, a wireless network signal processing algorithm is proposed, and a systematic method for designing the wireless network indoor coverage of the optical fiber distribution system is proposed, and the algorithms are compared and tested. The test results in this paper show that the signal strength obtained by the algorithm in this paper is -54.83 dB, while the traditional artificial design algorithm is only -45.97 dB. In addition, the wireless network base point of the algorithm in this paper is also 3 lower than the traditional one. Moreover, the coverage rate achieved by the algorithm in this paper is 3.17% higher than that of the network cable network base point layout given by the genetic algorithm, and the average received signal strength is 3.34 dB higher. In addition, the algorithm in this paper takes 9.1 s, 11.2 s, and 5.3 s for the three scenarios of underground parking lot, large shopping mall, and residential residential area, while the traditional manual design algorithm takes 87.9 s, 108.8 s, and 51.7 s, respectively. The algorithm in this paper is only about 1/10 of the traditional artificial design algorithm. Therefore, it can be concluded that the coverage effect of the wireless network indoor coverage system of the optical fiber distribution system designed in this paper is significantly improved.

Wireless optical receivers for wire local area networks

Wireless Infrared Computer Control

A 11 Mw 2.4 GHz 0.18 Μm CMOS Transceivers for Wireless Sensor Networks

A 100mhz-2ghz Wireless Receiver In 40-Nm Cmos For Software-Defined Radio

Photonic Applications in Wireless Terminal Networks

Indoor Infrared Wireless Communication System Based on Ethernet Network

Design of physical layer management module of optical wireless local area network

Wireless optical power transfer system incorporating a wide-field-of-view optical receiver

Broadband Nanophotonic Wireless Links and Networks Using On-Chip Integrated Plasmonic Antennas.

Development of an optoelectronic integrated circuit for indoor optical wireless communication systems

Evolution of Short-Range Optical Wireless Communications

9.2 A 13.3mW 500Mb/s IR-UWB transceiver with link-margin enhancement technique for meter-range communications

A 10-Gb/s Wireline Receiver Using Linear Baud-Rate CDR and Analog Equalizer for Free Space Optical Communication Over 10-and 100-m Distances

The Wireless Transmission of the Electric Power Parameter Data with the Wireless Receiving and Dispatching Module

Wireless Optical Communication-Based Spatial Pattern

Automatic Axis-Aligned High-Speed Optical Wireless Communication System Based on Laser Diode

Optical Wireless Communication Systems, A Survey

Application of Single Photon Detection in Wireless Optical Communication Transceiver Technology

Cost-efficient half-duplex 10 Gbit/s all-optical indoor optical wireless communication enabled by a low-cost Fabry-Perot laser/photodetector

Propagation Analysis and Experiment of Near-Infrared VCSEL-based Diffuse Optical Wireless Communication.

Development of Wireless Network Indoor Coverage System Based on Optical Fiber Distribution System