Abstract:This paper presents numerical investigation of stress distribution within fiber optic taper during its drawing process. A thermoviscoelastic model is proposed to describe the glass mechanical behavior from solid to liquid in a broad temperature range where the fiber optic taper drawing undergoes. The model is validated by experiments and used to study stress distribution in the fiber optic taper during fabrication. Roles of key parameters are discussed including geometrical configuration of the furnace, temperature difference between heating and cooling regions and drawing speed. Results show that the stress distribution is mainly influenced by thermal environment surrounding the taper. While the afore-mentioned key parameters all affect the thermal environ-ment, they thus also change the stress distribution in the fiber optic taper. A shorter length of adiabatic region and smaller temperature difference between the heating region and cooling region make the impact of cooling region on thermal environment to fiber drawing more significantly. Conversely, a longer adiabatic region and a larger temperature difference will enhance the impact of heating region. Proper increase in drawing speed can promote heat transfer arising from rheologic motion, thus improving the homogeneity of stress distribution in the fiber taper. Based on the understanding derived from this study, an improved heating and drawing design is proposed to achieve more homogeneity of stress in fiber optic taper during the drawing process.

Method of controlling drawing force in the fused biconical tapering process and simulation of electro-magnetic force

Theory and Compensation Method of Axial Magnetic Error Induced by Axial Magnetic Field in A Polarization-Maintaining Fiber Optic Gyro

FEA-Based Mathematical Modeling and Simulation for IPMSM Drive with Consideration of Saturation and Cross-Coupling Influence

Comparative Study of Flux-Weakening Control Methods for Pmsm Drive over Wide Speed Range

Modelling Self-Sensing of A Magnetostrictive Actuator Based on A Terfenol-D Rod

Coupling Nonlinear Dynamic Finite Element Model of Giant Magnetostrictive Actuator

Modeling of Tension Control System with Passive Dancer Roll for Automated Fiber Placement

Study on Coil Tension Fuzzy Control by Rotary Magnetorheological Damper

Electromagnetic Actuated Flexible Laser Fiber Steering Monitoring Based on Self-Sensation and Precalibration.

Modeling and Analysis of Force Prediction in Milling Process of Unidirectional Fiber Reinforced Polymer Composites

Detent Force Analysis and Optimization of Permanent Magnet Linear Synchronous Motor

Control of Stress Distribution During Large Radius Fiber Optic Taper Drawing Process Based on 2D Simulation

Numerical Simulation of Drawing Process for Bi Superconducting Single-filament Tape

Theoretical and Numerical Analysis for Design of High Ratio Fiber Optic Taper Drawing Process

Modeling and Design of a 3-DOF Magnetic Bearing with Toroidal Radial Control Coils

Control of Dual Three-Phase Permanent Magnet Synchronous Motor under Open Phase Fault Conditions

Current Compensation Control of Multiple Frequency Vibrations of the Rotor in Active Magnetic Bearing High Speed Motors

Active control with multi-frequency transmission force of multi-span rotor system

Model predictive flux control for permanent magnet synchronous motor

A Direct Electromagnetic Force Closed-loop Control Strategy for a Contactor

Conceptual design of magnetic force control system using wedge mechanism