Abstract:Abstract Multi‐objective optimization of the main bearing assembly structure entails a high computational cost; moreover, the experimental measurement of the main‐bearing‐hole out‐of‐roundness has the problem of poor accuracy and inadequate repeatability. To address these issues, an improved NSGA‐II algorithm based on the fixed‐sized candidate set adaptive random testing (FSCS‐ART) algorithm and an adaptive strategy is proposed, and a more accurate method for measuring out‐of‐roundness based on the compensation method is developed. Accordingly, a mathematical model and a parametric model are established for optimization. Finally, the optimal design scheme is obtained by solving with the improved NSGA‐II algorithm. The results show that the proposed out‐of‐roundness measurement method has a high accuracy, with <5% error. The improved NSGA‐II algorithm exhibits a better solution convergence compared with the original algorithm does. The optimized solution of the improved NSGA‐II algorithm has a higher fitness when the two algorithms evolve to the same generation in the late stage, and the distribution of the Pareto optimal of the improved algorithm solution is closer to the Pareto frontier. After optimization, the stresses at the danger areas of the engine block and bearing cap are reduced by 13.67% and 6.71%, respectively. The out‐of‐roundness of the main bearing hole is reduced by 14.13%, and the maximum contact pressure on the dangerous contact surface is reduced by 14.08%. This study makes a significant contribution to the design of internal combustion engines because it facilitates the development of high‐power diesel engines by optimizing the reliability of the main bearing assembly structure.

Multi-objective optimization of hydrostatic bearing of hollow shaft based on surrogate model

Multi-objective Optimization Design of Sliding Bearing of High-speed Centrifugal Pump Based on Lubrication Characteristics Analysis

Multi-Objective Optimization of Multistage Centrifugal Pump Based on Surrogate Model

Structural Multi-objective Optimization Design of Air-suspending Frictionless Pneumatic Cylinders

Hydrostatic bearing groove multi-objective optimization of the gear ring housing interface in a straight-line conjugate internal meshing gear pump

Optimization Tool Based on Multi-Objective Adaptive Surrogate Modeling for Surface Texture Design of Slipper Bearing in Axial Piston Pump

Multi‐objective optimization of main bearing assembly structure based on improved NSGA‐II

Multi-objective Optimization of Micron-Scale Surface Textures for the Cylinder/valve Plate Interface in Axial Piston Pumps

Optimization of a Centrifugal Pump to Improve Hydraulic Efficiency and Reduce Hydro-Induced Vibration

Sequential Multi-Objective Optimization for Lubrication System of Gasoline Engines with Bilevel Optimization Structure

Multi Objective Optimization Research on Power Consumption and Stiffness of Internal Feedback Hydrostatic Turntable

Multi-objective intelligent cooperative design for interference fit of the conical sleeve

Bi-level optimization and integrated multiple-criteria decision making under uncertainty for structural design of insulated bearings

Multidisciplinary Design Optimization of Alignment and Whirling Vibration Characteristics of a Submarine Propulsion Shafting Using Kriging Surrogate Model

Reliability-Based Design Optimization Applied to a Rotor Supported by Hydrodynamic Bearings

A novel concept for multi-objective optimization of composite power transmission shafts

Multi-Objective Parameter Optimization-Based Design of Six-Pole Radial Hybrid Magnetic Bearing

Multi-objective optimization of tribological properties of camshaft bearing pairs using DNN coupled with NSGA-II algorithm and TOPSIS

Operation parameters multi-objective optimization method of large vertical mill based on CFD-DPM

Effects of Hyperelliptic Bearings Bush on Connecting Rod Big-End Lubrication and Design Optimization