Abstract:Ring opening polymerization of epsilon-caprolactone was realized in the presence of monomethoxy poly(ethylene glycol) with M-n = 1000 and 2000, using Zn(La)(2) as catalyst. The resulting PCL-PEG diblock copolymers with CL/EO repeat unit molar ratios from 0.2 to 3.0 were characterized by using DSC, WAXD, SEC, and H-1 NMR. The crystal phase of PCL blocks exist in all polymers, and the crystallization ability of PCL blocks increases with CL/EO ratio. PEG blocks are able to crystallize for copolymers with CL/EO below 1.0 only. Melt crystallization results were analyzed with Avrami equation. The Averami exponent n is around 3.0 in most cases, in agreement with heterogeneous nucleation with three dimensional growth. The morphology of the crystals was observed by using POM. Rod-like crystals were found to grow in 1, 3 or 2, 4 quadrants for samples with low molecular weights. In the case of a copolymer with M-n,M-PEG = 2000 and M-n,M-PCL = 800, PEG blocks could crystallize and grow on PCL crystals after PCL finished to form rod-like crystals, leading to formation of poorly or well structured spherulites. The spherulite growth rate (G) was determined at different crystallization temperatures (T-c) ranging from 9 to 49 degrees C. All the copolymers present a steady G decrease with increasing crystallization temperature due to lower undercooling. On the other hand, increase of CL/EO ratio leads to increase of G in the same T-c range. (C) 2009 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 48: 286-293, 2010

The Formation of Methoxyl Poly(ethylene Glycol)-B-polycaprolactone (Mpeg-B-pcl) Microspheres by O/O Emulsion/Solvent Evaporation Method

Micellization Phenomena of Amphiphilic Block Copolymers Based on Methoxy Poly(ethylene glycol) and Either Crystalline or Amorphous Poly(caprolactone-<i>b</i>-lactide)

Preparation of Poly (L-Lactic Acid) Microsphere

Microwave-Assisted Synthesis and Micellezation of Methoxypolyethylene Glycol/Poly(ε-Caprolactone) Block Copolymer

A Detailed View of PLGA-mPEG Microsphere Formation by Double Emulsion Solvent Evaporation Method

Preparation of Porous Polylactide Microspheres by Emulsion‐solvent Evaporation Based on Solution Induced Phase Separation

The Influence of Hydrophilic Mpeg Segment on Formation, Morphology, and Properties of PCL‐mPEG Microspheres

Preparation of Microcapsules with Silicone Oil As Continuous Phase Using A Solvent Evaporation Method

Make microspheres through emulsion-solvent evaporation method

Synthesis and Degradation Behavior of Miktoarm Poly(ɛ-Caprolactone) 2 - B -Poly( L -Lactone) 2 Microspheres

Microstructurally Tunable Pickering Emulsions Stabilized by Poly(ethylene Glycol)-B-poly(ε-caprolactone) Diblock Biodegradable Copolymer Micelles with Predesigned Polymer Architecture.

Preparation of Biodegradable Polyesteramide Microspheres

Studies on Dynamic Process and Related Physical Characteristics of PLGA Microsphere Prepared by Double-Emulsification Method

Preparation of morphine loaded PLLA-PEG-PLLA microspheres by supercritical fluid technique

Melt Crystallization And Morphology Of Poly(Epsilon-Caprolactone)-Poly(Ethylene Glycol) Diblock Copolymers With Different Compositions And Molecular Weights

Synthesis and Micellization of Poly(E-Caprolactone)/Poly(Ethyl Ethylene Phosphate)Block Copolymer

Preparation of Uniform-sized PELA Microspheres Containing Lysozyme by Membrane Emulsification and Double Emulsion-Solvent Removal Method

Melt Crystallization and Morphology of Poly(ε‐caprolactone)‐poly(ethylene Glycol) Diblock Copolymers with Different Compositions and Molecular Weights

Toward Understanding the Effect of Solvent Evaporation on the Morphology of PLGA Microspheres by Double Emulsion Method

Preparation and Characterization of Monodisperse Methyl Methacrylate-Styrene Copolymer Microspheres

Crystallization-driven Formation Poly (L-Lactic Acid)/poly (D-Lactic Acid)-Polyethylene Glycol-Poly (L-Lactic Acid) Small-Sized Microsphere Structures by Solvent-Induced Self-Assembly