Melt Crystallization and Morphology of Poly(ε‐caprolactone)‐poly(ethylene Glycol) Diblock Copolymers with Different Compositions and Molecular Weights

Y. Xu,Yan Zhang,Zhongyong Fan,Suming Li

DOI: https://doi.org/10.1002/polb.21874

2010-01-01

Abstract:Ring opening polymerization of e-caprolactone was realized in the presence of monomethoxy poly(ethylene glycol) with M n = 1000 and 2000, using Zn(La) 2 as catalyst. The resulting PCL-PEG diblock copolymers with CUEO repeat unit molar ratios from 0.2 to 3.0 were characterized by using DSC, WAXD, SEC, and 1 H NMR. The crystal phase of PCL blocks exist in all polymers, and the crystallization ability of PCL blocks increases with CUEO ratio. PEG blocks are able to crystallize for copolymers with CUEO below 1.0 only. Melt crystallization results were analyzed with Avrami equation. The Averami exponent n is around 3.0 in most cases, in agreement with heterogeneous nucleation with three dimensional growth. The morphology of the crystals was observed by using POM. Rod-like crystals were found to grow in 1, 3 or 2, 4 quadrants for samples with low molecular weights. In the case of a copolymer with M n.PEG = 2000 and M n,PCL = 800, PEG blocks could crystallize and grow on PCL crystals after PCL finished to form rod-like crystals, leading to formation of poorly or well structured spherulites. The spherulite growth rate (G) was determined at different crystallization temperatures (T c ) ranging from 9 to 49 °C. All the copolymers present a steady G decrease with increasing crystallization temperature due to lower undercooling. On the other hand, increase of CL/EO ratio leads to increase of G in the same T c range.