Feasibility study on the micro-forming of novel metal foil arrays based on submerged cavitating water-jet impingement
Lian Zhou,Wei Meng,Fuzhu Li,Honglei Ma,Yun Wang,Jingyi Wu
DOI: https://doi.org/10.1177/16878132241277330
IF: 2.1
2024-09-22
Advances in Mechanical Engineering
Abstract:Advances in Mechanical Engineering, Volume 16, Issue 9, September 2024. With the increasing demand for metal foil parts with micro-array structures in micro-electromechanical systems (MEMS), it is urgent to explore a novel array micro-forming technology with high efficiency, low cost, and high flexibility. The cavitation water jet uses the high-energy shock wave generated by the collapse of the cavitation bubble group as the loading force. It has the characteristics of large range of action, uniform pressure distribution, and can realize large-area array micro-forming processing. To verify the feasibility of cavitating water jet array micro-forming, this paper performs cavitating water jet array micro-forming on 304 stainless steel foil with a thickness of 80 μm, and analyzes the variation of cavitation bubbles collapse impact zone with target distance. The effects of target distance and impact time on the forming quality of metal foil array micro-holes were studied from the aspects of forming depth, surface roughness, and thickness thinning rate. The results show that the forming depth and uniformity of the array micro-holes located in the cavitation collapse area increase with time. However, with the increase of target distance, the forming depth increases first and then decreases. When the target distance is L = 120 mm, the forming depth reaches the maximum. The surface roughness (Ra) of the array micro hole is Ra = 1.54 μm. The thickness thinning rate of the micro-forming parts is between 2% and 10%, and the maximum thickness thinning rate in the die fillet area is 13.5%. This paper provides a novel processing method for manufacturing metal foil parts with micro array structure.
engineering, mechanical,thermodynamics