Abstract:Although existing studies have emphasized the effects of micro-structured surfaces and vibration conditions on spray cooling efficiency. However, there is a research gap on how the coupling effect of these two factors affects spray cooling heat transfer. Therefore, in this study, the heat dissipation capacity of spray cooling under different vibration and microstructure size conditions is investigated experimentally using commercial HFE-649 as the coolant. The coolant is an electronic fluid with a global warming potential of only 1. Its low boiling point (49°C), which facilitates the early realisation of the phase change process, has a high potential for application in thermal management systems. The study reveals that both vibration and micro-structured surfaces significantly enhance the heat flux and heat transfer coefficient (HTC) in spray cooling. The combined effect of vibration and microstructures results in a more pronounced enhancement of cooling capacity, with the HTC increasing by 44% compared to a static smooth surface. As the vibration frequency and the side length ( w ) of the square fins on the micro-structured surface increase, the heat flux, HTC, critical heat flux (CHF), cooling efficiency, and heat transfer enhancement ratio (HTER) all show an increasing trend. However, at high vibration Reynolds numbers ( Rev ) (15708) and the w of the square fins of 0.8mm and 1.0mm, there is a notable decline in spray cooling capacity due to the excessively high Rev enhances the reciprocating motion of the liquid film, causing the film to inadequately spread and continuously accumulate around the edges. A correlation for heat dissipation capability of spray cooling under the coupled effects of vibration and micro-structured surfaces was derived and fitted, with the error in CHF within 12%.

Coupling Mechanism Between Centrifugal Acceleration and Thermo-Field

Characteristics of Temperature Field in a Closed Cavity with Centrifugal Acceleration

Control of Temperature Uniformity in the Temperature Chamber with Centrifugal Acceleration

Simulation of Pressure Field under Centrifugal Acceleration Based on FLUENT

Thermal-Vibration Combined Environment Under High Linear Acceleration

Study on Test System of Thermal-Vibration Combined Envir Onment under High Linear Acceleration

Analysis on Dynamic Characteristics and Design of Centrifuge

Development of Centrifuge for Multi-Parameter Combined Environmental Test

Experimental Research on Heat Conduction and Temperature Control Method in the Chamber of Large-Scale Geotechnical Centrifuge

Study on Electromechanical Coupling Characteristics of Electric Vibration Table in High-Translational-Acceleration

Analysis of Temperature Field Distribution of Magnetic-Fluid Bearing for High-Speed Trains

An Experimental Study on Aerodynamic Characteristics of Hypergravity Centrifugal Facility

The Coupling Effect of Surface Vibration and Micro-structure on Spray Cooling Heat Transfer

MHD Convective Heat Transfer with Temperature-Dependent Viscosity and Thermal Conductivity: a Numerical Investigation

Multi-field coupling numerical analysis approach for aerothermal environment of hypersonic vehicles

Research on the mechanical properties of magnetorheological fluid under electromagnetic-thermal coupling

Dynamic simulation of nozzle structure based on thermal-fluid-solid coupling analysis

Recent research progress on fluid-thermal-structural coupling analysis in hypersonic flows

Coupling Calculation and Experiment of Fluid Flow and Heat Transfer of a New Rotating Induction Heater

Temperature Rise Calculation of the High Speed Magnetic Suspension Motor Based on Bidirectional Electromagnetic–Thermal–Fluid Coupling Analysis

The thermo-mechanical coupling method of brake disc based on dynamic convective heat transfer