Abstract:Although existing studies have emphasized the effects of micro-structured surfaces and vibration conditions on spray cooling efficiency. However, there is a research gap on how the coupling effect of these two factors affects spray cooling heat transfer. Therefore, in this study, the heat dissipation capacity of spray cooling under different vibration and microstructure size conditions is investigated experimentally using commercial HFE-649 as the coolant. The coolant is an electronic fluid with a global warming potential of only 1. Its low boiling point (49°C), which facilitates the early realisation of the phase change process, has a high potential for application in thermal management systems. The study reveals that both vibration and micro-structured surfaces significantly enhance the heat flux and heat transfer coefficient (HTC) in spray cooling. The combined effect of vibration and microstructures results in a more pronounced enhancement of cooling capacity, with the HTC increasing by 44% compared to a static smooth surface. As the vibration frequency and the side length ( w ) of the square fins on the micro-structured surface increase, the heat flux, HTC, critical heat flux (CHF), cooling efficiency, and heat transfer enhancement ratio (HTER) all show an increasing trend. However, at high vibration Reynolds numbers ( Rev ) (15708) and the w of the square fins of 0.8mm and 1.0mm, there is a notable decline in spray cooling capacity due to the excessively high Rev enhances the reciprocating motion of the liquid film, causing the film to inadequately spread and continuously accumulate around the edges. A correlation for heat dissipation capability of spray cooling under the coupled effects of vibration and micro-structured surfaces was derived and fitted, with the error in CHF within 12%.

Heat transfer and field synergy characteristics in a rectangular unit channel under mechanical vibration

Environmental vibration induced by vehicle in complicated field

Simulation, Experimentation, and Collaborative Analysis of Adjacent Heat Exchange Modules in a Vehicular Cooling System

Study on the vertical oscillatory gas-liquid two-phase flow and heat transfer characteristics

Coupling Mechanism Between Centrifugal Acceleration and Thermo-Field

Effect of mechanical vibration and its influence on thermal performance of a nanofluid heat exchanger

Effect of vertical vibration on transient heat transfer characteristics of flow boiling in small rectangular channels

Analysis of transverse vibration response and heat transfer characteristics of heat exchangers based on elastic structures

Experimental research on vibration-enhanced heat transfer of fin-tube vehicle radiator

Numerical Simulation of Fluid-Elastic Instability in Heat Exchanger Tube Bundles

Effect of forced lateral vibration on flow and heat transfer performance within an annular fuel element

Numerical Simulation of the Steady Vibration Response Induced by Interior Flow of Heat Exchangers

The Coupling Effect of Surface Vibration and Micro-structure on Spray Cooling Heat Transfer

New Idea of Heat Exchanger for Study of Flow-induced Vibration for Tube Arrays in Cross-flow

Study of laminar convection heat transfer in single-side-heating small-scale cooling channel with vibration cylinder

Heat transfer of single-phase spray cooling on heated vibrating surfaces

Numerical Analysis on Heat Transfer Performance of Oscillating Flow in Wavy Channel

Numerical Simulation of Flow-Induced Vibration of Three-Dimensional Elastic Heat Exchanger Tube Bundle Based on Fluid-Structure Coupling

Experimental and Theoretical Analysis for Heat Transfer and Flow Performance of Mini-channel Parallel Flow Heat Exchanger in Vehicle

Study on Vibration and Heat Transfer Performances of a Modified Elastic Tube Bundle Heat Exchanger

Numerical study on vibration heat transfer enhancement of multi-configured blunt-headed cylinder with fin device