Abstract:Improving the physical and mechanical properties such as hardness and strength of metal thin films can be achieved by incorporating nanoparticles into the pure metals, for example via electrocodeposition. However, the agglomeration of nanoparticles during electrocodeposition of nanocomposite thin films is an unresolved issue. This paper presents the preliminary results of electrocodeposition thin nanocomposite films under different processing conditions. The microstructure and distribution of Al2O3 nanoparticles in electrocodeposited Cu matrix nanocomposite thin films on a pure Al plate were examined. In addition, the effect of electrolyte concentration on the agglomeration of nanoparticles was studied. Different stirring times were used for electrodepositing the alumina/Cu nanocomposite and the pure Cu control film. Under the constant stirring condition, different deposition times including 1, 4, 8, 12, and 24 hours were taken to study the differences between the agglomeration states of the alumina nanoparticles with the time change. We also examined the effect of turning the electromagnetic stirrer ON and OFF at different time intervals from as short as every 20 minutes to as long as ON and OFF every 2 hours on the nanoparticle agglomeration in the film Optical and electron microscopic studies were made to reveal the microstructure of the nanocomposite. It is found that there is no significant difference in microstructures for the specimens that made under either intermittent stirring or constant stirring for the same length of time.

Preparation of Cu-based composite materialsreinforced by nanotube by powder-metallurgy

SYNTHESIS AND THE PERFORMANCE OF CARBON NANOTUBES-(Ni-P) COMPOSITES

Preparation method of carbon nano tube enhanced copper-based composite material

Preparation and Tribological Properties of the Carbon Nanotubes–ni–p Composite Coating

Influence on (Ni-P) Electroless Composite Plating with Carbon Nanotubes

Sintering Densification of Cu/Al2O3p Nano-Composite Powders by Electroless Copper Plating

Progress of CNTs Reinforced Copper-based Composite Preparation

Tribological Application of Carbon Nanotubes in a Metal-Based Composite Coating and Composites

Nanoparticle Reinforced Metal Composites Prepared by Electrocodeposition

Research of Carbon Nanotubes-Cu Composite with Interpenetrating Networks

Mechanical Properties of Cu-Based Composites Reinforced by Carbon Nanotubes

Study of Hot-press Sintering Process of Nanometer Cu-Al_2O_3 Composite

Effect of carbon nanotube content and annealing temperature on corrosion performance of carbon nanotube/Ni composite layer

Mechanical and Conductive Properties of Cu Matrix Composites Reinforced by Oriented Carbon Nanotubes with Different Coatings

Strengthening Ni-Coated CNT/Mg Composites by Optimizing the CNT Content

Study on the Properties of Carbon Nanotube (CNTs) Reinforced AlSi10Mg Composites Fabricated by Powder Metallurgy

Properties of Carbon Nano-tubes/Magnesiuum Matrix Composite by Casting

Nano-silver modified carbon nanotubes to reinforce the copper matrix composites and their mechanical properties

Optimization of the mechanical properties of CNTs/Cu composite by regulating the size of interfacial TiC

A Study of Silver Decoration on Carbon Nanotubes via Ultrasonic Chemical Synthesis and Their Reinforced Copper Matrix Composites

Enhancement of mechanical properties and conductivity in carbon nanotubes (CNTs)/Cu matrix composite by surface and intratube decoration of CNTs