Abstract:This paper is concerned with an experimental study on a wedge-bonded anchor for carbon fibre reinforced polymer (CFRP) tendons under cyclic loading. The adhesive reinforced by quartz sand was tested to be superior as a bonding material for the anchor when compared to the adhesive reinforced by ferrous powder or aluminate powder. Structural responses of the wedge-bonded anchor under cyclic loading were analyzed with regard to system slip, sleeve strain, temperature rise in the anchor zone and residual tensile load capacity. The results indicate that the maximum stress level and stress ratio influence significantly the fatigue performance of wedge-bonded anchors. A cyclic loading with a high stress ratio and low stress level is beneficial due to the synergetic effect of the components in the wedge-bonded anchors. However, enhancing the stress level or lowering the stress ratio leads to a larger slip, greater damage and more loading cycles are needed for the stabilization of wedge-bonded anchors. When the stress ratio exceeds 0.4 and the maximum stress is less than 0.5, damage in anchor zone is initiated and developed in the early stage of cyclic loading, but the anchor becomes stable finally. A large decrease in stress ratio may result in a continuous development of microstructural damage and the eventual failure of the anchor, accompanied by continuously increasing energy dissipation under cyclic loading. The axial strain of sleeve in a wedge-bonded anchor is influenced by the extent of damage evolution and the synergetic effect of anchor assemblies: thereby resulting in different trends in sleeve strain-cycle curves under different stress ratios and stress levels. The temperature rise may be pronounced at a loading frequency of 10 Hz or less, which is related to the stress ratio. The damage development in the wedge-bonded anchor with an infinite fatigue life was analyzed. The mechanism of fatigue damage in wedge-bonded anchors is different from that of adhesively bonded anchors. Moreover, wedge-bonded anchors have a stronger resistance against fatigue due to the interaction between the wedges and the other assemblies. (C) 2019 Elsevier Ltd. All rights reserved.

Experimental Study on the Wedge-Bond Anchorage of CFRP Tendons

Experimental Study of the Wedge-sleeve Anchorage of CFRP Tendons

Wedge-bond Anchorage of CFRP Tendons

EXPERIMENTAL INVESTIGATION AND FINITE ELEMENT ANALYSIS OF WEDGE-BOND ANCHORAGE FOR CFRP-TENDONS

Experimental investigation on the performance of wedge-bond anchors for CFRP tendons

Development and Assessment of a Novel Mechanical Wedge-Type Anchorage System for CFRP Tendon

Fatigue Behavior of Wedge--type Anchorage for CFRP Tendon

Experimental Study on Wedge-Bonded Anchors for CFRP Tendons under Cyclic Loading

Experimential Investigation on the Wedge-Type Achor for Cfrp Tendon

Experimental Investigation on the Anchorage Performance of CFRP Tendon in Different Bond Mediums

Synergistic Effect of a New Wedge-Bond-type Anchor for CFRP Tendons

Finite Element analysis and experimental study of static performance of multi‐CFRP tendon composite anchorage system

Static Load Tests Study of Improved Anchors for CFRP Tendon

Composite-Wedge Anchorage for Fiber-Reinforced Polymer Tendons

Design of Wedge-type Anchors for CFRP Tendons

Experimental and Numerical Investigation of the Mechanical Properties of a CFRP Tendon–Wedge Assembly Loaded under Transverse Compressive Loading

Experimental Investigation on the Mechanical Properties of a Noval Bond-Type Anchorage for Carbon Fiber Reinforced Polymer Tendons

Experimental investigation of a bond-type anchorage system for multiple FRP tendons

Design optimization and experimental validation of a novel wedge-shaped bond anchorage system for prestressed CFRP plates

Experimental Study on Fatigue Performance of Adhesively Bonded Anchorage System for CFRP Tendons

Analysis of mechanical behavior of bonding anchorages for CFRP tendons