Abstract:With the raise of resolution, optical payloads are becoming increasingly sensitive to satellite jitter. An approach where the entire spacecraft is pointed with great accuracy requires sophisticated and expensive bus design. In an effort to lower the overall cost of space missions that require highly stable line-of-sight pointing, a method of separating the bus and the payload with low frequency isolators is proposed. This isolation system can block the transmission of disturbance and allow relatively large bus motion. However, if the isolator is linear then there is a trade-off between isolation and static deflection as the launch and the on-orbit stage have difference requirements on the isolation frequency. Otherwise, an extra locking system should be appended to protect the payload before getting into orbit, as the STABLE isolation system[1] and the MIM isolation system[2] did. To overcome this limitation, an alternative approach is to design a nonlinear isolator with high-static stiffness during launch and low dynamic stiffness on orbit. Several specially designed nonlinear isolators have achieved low dynamic stiffness with large static load capacity. Virgin[3] considered a structure made from a highly deformed elastic element to achieve a softening spring. Platus[4] exploited the buckling of beams under axial load in a specific configuration to achieve a negative stiffness in combination with a positive stiffness, and hence low-dynamic stiffness. Others have achieved the same by connecting linear springs with positive stiffness in parallel with elements of negative stiffness[5]~[7]. In the present study, a bifunctional isolator has been developed for optical payloads. The isolator have good performance both during launch and on orbit because of its specially designed nonlinear stiffness and damping. The isolator works in a linear part with low stiffness and small damping ratio under the micro-vibration and microgravity on orbit. The transmissibility requirement and the displacement restriction during launch are satisfied by tuning the nonlinear stiffness and damping parameters. A group of sample isolators are designed tested both statically and dynamically.

Design and test for the shock isolation structure of a whole spacecraft

Research on Passive Isolation Characteristics and Rocket-spacecraft Coupling of a New Whole-spacecraft Isolation Platform

Simulation And Design Of Composite Vibration Isolator For Spacecrafts

A simulation model with numerical method and optimal control of magneto-rheological shock isolator

Anti-shock Performance of a Cockroach-Inspired Structure

Experiment on Active Vibration Isolation of a Conical Shell Isolator

Response and Performance of A Nonlinear Vibration Isolator with High-Static-Low-Dynamic-Stiffness under Shock Excitations

Application of Stress Wave Theory for Pyroshock Isolation at Spacecraft-Rocket Interface

Parameter design and experimental study of a bifunctional isolator for optical payload protection and stabilization

Analytical Study of Whole Flexible Spacecraft Vibration Isolation

Analysis for the Principle of Whole-Spacecraft Vibration Isolation

Research on a Honeycomb Structure for Pyroshock Isolation at the Spacecraft–Rocket Interface

Study on Micro-vibration Isolation System Design and Validation for the SDLT-1 Satellite of China

Active Vibration Suppression of Payloads with a Conical Isolator

Study of Whole-Satellite Active Vibration Isolation Platform

Numerical and experimental investigation on the shock mitigation of satellite-rocket separation

Mechanical Shock Wave Suppression Structure in Hold-Down and Release Apparatus of Spacecraft

Modeling and Analysis of Bio-Inspired, Reconfigurable, Piezo-Driven Vibration Isolator for Spacecraft

Design of Clearance Fit Between Pico-Satellite and Its Separation Mechanism Based on Thermal-Structure Coupling

A Study on the Design of Isolator and the Mounting Method for Reducing the Pyro-Shock of a MEMS IMU

Dynamic Design of Octostrut Platform for Launch Stage Whole-Spacecraft Vibration Isolation