Abstract:Bearing shells are widely used in heavy-load friction pairs of high-end machines to reduce wear, thereby extending the lifetime of machines. Tribotests are necessary for bearing shells to evaluate their wear behaviors, reliability, and durability. Existing tribotests of bearing shells can mainly be categorized into two types: full-scale machine tests or local-scale standardized tests (pin-on-disk, etc.). The former has more realistic test configurations but is time/labor-consuming and expensive. Contrarily, the local-scale standardized tests are simple, low-cost, and flexible to use, but their oversimplified contact configurations make the measuring results in poor correlation with practical applications, easily misleading the screen of bearing shells. For that, this study develops a hybrid tribotest method and corresponding instrument (tribometer) to realistically measure the friction and wear of heavy-load bearing shells, which combines the advantages of the facticity of full-scale machine tests with the simplicity and inexpensive of local-scale standardized tests. In this method, a convenient round-arched concave on the bearing shell holder is designed to achieve the conformal contact friction of the bearing shells, of which the size can also be modifiable and compatible with different bearing shells. To reproduce the actual friction conditions in the machine, an easy-to-removal roller counterpart with an adjustable speed down to 0.5 r/min and a hydraulic loading with a controllable force exceeding 93 kN (equivalent to 9.3 ton) are employed to achieve the low speed and heavy load. Based on the method, both alloy- and polymer bearing shells are measured. The measuring results indicate the feasibility of the hybrid measurement method and tribometer. The proposed method offers a facile and actual way for screening structural/material, the wear mechanism analysis, and the contact configuration investigation of bearing shells.

Identification of Bearing Loads Based on Support Reaction Measuring

Simulation of dynamical loads for large controllable pitch propellers ground tests

Analysis of Testing Method for Dynamic Loads of Propulsion Shafting Systems

A Simplified Identification Method of Dynamic Stiffness for the Heavy-Load and Low-Speed Journal Bearings

Film-Thickness Identification Method and Lubrication Characteristic Experiment of Full-Size Water-Lubricated Stern Bearing under Offset Load

Experimental Study on the Effect of Hull Deformation on the Relative Attitude Between Shaft and Bearing

Equivalent Stiffness of the Rubber Stern Bearing of a Propulsion Shafting System

Research on Marine Intermediate Bearing Load Identification Technology

Study On Dynamic Characteristics Of Large Ship Rotor-Bearing System Based On An Advanced Water-Lubricated Rubber Bearing Model

Mechanical Behavior Monitoring and Load Inversion Analysis of Large-Diameter Underwater Shield Tunnel During Construction

Identification of Static Loading Conditions Using Piezoelectric Sensor Arrays

Hybrid Tribotest Method for Realistically Measuring Friction and Wear of Heavy-Load Bearing Shells

Theoretic and Experimental Research on the Influence of Ship Stern Bearing Deformation to its Carrying Capacity

Simulation and Experiment on Lateral Vibration Transmission Control of a Shafting System with Active Stern Support

The coupled effect of bearing misalignment and friction on vibration characteristics of a propulsion shafting system

Research an Online Monitoring Method of Propulsion Shafting Alignment Adapting to Hull Deformation

Experimental Study on the Dynamic Performance of Water-Lubricated Rubber Bearings with Local Contact

Principle and Measure Point Research of Bearing Oil-film Force Identification

Theoretical Analysis of the Influence of Stern Bearing Elevation on the Lateral Vibration of Shafting

Calculation method for axial dynamic characteristics of lubricant oil film in marine tilting pad thrust bearing

Online High-Precision Identification Method for Ship Propeller Thrust