Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Analysis of Influence of Rolling on Heat Transfer Characteristics of Two-phase Falling Film Flow of Refrigerant outside Horizontal Tubes

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Numerical Study of Heat Transfer Characteristic for Subcooled Falling Film outside the Shaped Tubes under Rolling Motion

Numerical Study on Flow Heat Transfer Characteristics of Horizontal Tube Falling-Film Evaporator

Effects of Sloshing Motions on Condensation Heat Transfer Characteristics of Integral-Fin Tubes Under Sea Conditions

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Numerical simulation of heat transfer characteristics of falling-film evaporation of R32/R134a non-azeotropic refrigerant outside a horizontal tube

Study on Flow and Heat Transfer Characteristics of Supercritical CO2 Inside Horizontal Tube under Ocean Rolling Condition

Study on boiling heat transfer characteristics of R410A outside horizontal tube under swaying condition

HEAT TRANSFER OPTIMIZATION OF THE HORIZONTAL TUBE BUNDLES IN FALLING FILM EVAPORATORS

Numerical Study on Heat Transfer of Two-Phase Fluid in Helical Coil Pipe under Ocean Condition

Numerical simulation of flow characteristics of falling-film evaporation of R32/R134a non-azeotropic refrigerant outside a horizontal tube

Experimental study on two-phase flow instability in helically coiled tube under rolling motion

Influence of Lubricant Oil on Heat Transfer Performance of Refrigerant Flow Boiling Inside Small Diameter Tubes. Part I: Experimental Study

Refrigerant Film Flow and Heat Transfer Characteristics on the Elliptical Tube under Constant Wall Temperature

The Heat Transfer Characteristic of Shell-Side Film Flow in Spiral Wound Heat Exchanger under Rolling Working Conditions

Experimental Study of the Falling Film Evaporative Cooling on Horizontal Tubes Plates

Experimental research on falling film flow and heat transfer characteristics outside the vertical tube

Experimental Investigation on the Heat Transfer Performance of Falling Film with Deionized Water on Horizontal Tubes

Numerical Simulation on the Flow and Heat Transfer Characteristics in the One-Side Heating Helically Coiled Tubes

Heat Transfer Performance for A Falling-Film on Horizontal Flat Tubes