Application of response surface methodology in the process optimization of WC-12Co coatings by APS

Cunguang LIANG,Xinmei LI
DOI: https://doi.org/10.11951/j.issn.1005-0299.20170126
IF: 1.8
2018-01-01
Materials Science and Technology
Abstract:To improve the quality of WC-12Co coatings,the WC-12Co coating was deposited on Q235 substrate by atmospheric plasma spraying(APS)technology under different process conditions and micro-hardness values of coating were measured as the response values. The mathematical model was established between the influence factors such as spraying current,plasma gas flow,spray distance and the response values of micro-hardness. The significance of single factor and interaction effects were also discussed, and BP neutral network(3×9×1)was applied to compare with the results of polynomial regression model. The optimized parameters were verified by experimental method, and the effects of different spraying distance on the microstructure and properties of the coatings were analyzed.Results showed that the complex correlation coefficient of polynomial regression model was 0.979 9,and that of BP neutral network model was 0.999 1.The average relative error of neural network was 0.46%, which was lower than that of polynomial regression model of 1.56%. Influence of spraying distance on the micro-hardness of coating is the most significant.The maximum micro-hardness of 1 336.9 HV0.5could be obtained under the optimal parameters of the current of 390 A,flow of argon of 2 500 L/h and spray distance of 130 mm.
What problem does this paper attempt to address?