Effects Of Spraying Distance On Erosion Wear Behavior Of Wc-12co Coatings Prepared By Aps

Liang Cun-Guang,Li Xin-Mei

DOI: https://doi.org/10.11933/j.issn.1007-9289.20170516002

2017-01-01

China surface engineering

Abstract:In order to improve the erosion resistance of coatings. WC-12Co composite coatings were prepared on Q235 steel by atmospheric plasma spraying (APS) method. The microstructure, mechanical properties and erosion resistance of the coatings under different spraying distance were studied. The results show that the spraying distance has an obvious influence on coating preformance. When the spraying distance is 130 mm, the particle velocity and temperature matches well, and the quality and erosion resistance of the coatings are better than others. The corrosion resistance of the coatings sprayed by 120 mm and 140 mm is poor. The wear mass loss of the coating is the largest when the diameter of sand is 30 mesh. When the velocity of sand is 15.68 m/s, the wear mass loss of the coatings is larger than that of 13.33 m/s. The wear loss firstly increases, then decreases with the growth of the erosion angle, and attains the maximum value when the erosion angle is 60 degrees.