Abstract:Owing to high heat flux ability and good mechanical strength, copper has been used for micro-electro-mechanical systems (MEMS) components with dimensions in micrometers processed by electrochemical methods. In the present study, fine grained copper foils of different thicknesses and grain sizes produced by pulsed electrodeposition under different controlled current densities were used to investigate the effect of total number of grains across thickness of foil on its tensile response and formability. For a comparative study, commercially available rolled Cu foils were also used. Vacuum annealing was employed to obtain a wide range of fully recrystallized grain sizes within same thickness of the foils. Detailed microstructural characterization was carried out using scanning electron microscope attached with electron backscattered diffraction detector. The foils were subjected to uniaxial tensile testing and formability testing using a miniaturized Nakazima test setup. As anticipated, finer the grain size higher was the yield strength. However, the strength of copper reduced with decreasing the total number of grains across thickness of the foil. The electrodeposited Cu foil exhibited relatively higher strength levels but reduced tensile ductility along with decreased strain hardening ability compared to the fully recrystallized Cu foils having similar grain sizes. Furthermore, the number of grains across thickness and the prior history of foils played significant role on the shape and trend in variation of the forming limit curve of Cu. An α-fiber (< 110 >) texture evolved in Cu during deformation and its volume fraction strengthened under biaxial deformation conditions.Graphical

Research of Size Effects on Tensile Strength and Elongation of Copper Foil

SIZE EFFECTS OF YIELD STRENGTH OF BRASS FOIL IN TENSILE TEST

Size Effect on Mechanical Properties and Texture of Pure Copper Foil by Cold Rolling

Influence of Specimen Dimensions on the Tensile Behavior of Ultrafine-Grained Cu

Specimen Dimension and Grain Size Effects on Deformation Behavior in Micro Tensile of Sus304 Stainless Steel Foil

Experimental Study on Specimen and Grain Size Effects in Uniaxial Tension Test of Aluminum Foil

Size Effect on the High Strain Rate Micro/meso-Tensile Behaviors of Pure Titanium Foil

Processing and Specimen Thickness to Grain Size (t/d) Ratio Effects on Tensile Behaviour and Microformability of Copper Foils

Tensile Test and Surface Layer Effect of Ultra Fine Grain Thin Copper Sheet Prepared by Electrodeposition

Size effect on the fracture toughness of metallic foil

Mechanical Properties and Microstructure of Rolled and Electrodeposited Thin Copper Foil

Effect of Grain Size on the Mechanical Properties and Formability of AA8021 Aluminum Foil

Experimental and Numerical Studies of Coupling Size Effects on Material Behaviors of Polycrystalline Metallic Foils in Microscale Plastic Deformation

Study on tensile fracture of pure copper plate with a center hole

Investigation of the Size Effects on the Elongation of Ti-2.5Al-1.5Mn Foils with Digital Image Correlation Method

Size Effect on Deformation Behavior and Ductile Fracture in Microforming of Pure Copper Sheets Considering Free Surface Roughening

Size Effect Studies on Tensile Tests for Hot Stamping Steel

Influence of specimen dimensions and strain measurement methods on tensile stress–strain curves

Study of Size Effects on Deformation Behavior and Formability in Micro Metal Forming of Ti Foil

Size Effects of CuZn37 Brass Foil in Microforming

Grain Size Effect of Commercial Pure Titanium Foils on Mechanical Properties, Fracture Behaviors and Constitutive Models