Ceramic Surface Modification by Ni- Ti Compound Plating and Ceramic Brazing

ZHANG Yong-qing,REN Jia-lie,ZHAO Peng-sheng

DOI: https://doi.org/10.3969/j.issn.1005-0299.2005.03.020

IF: 1.8

2005-01-01

Materials Science and Technology

Abstract:In order to metallize ceramics surface, the Ni-Ti compound plating was used. The ceramic to metal was brazed in glow discharge furnace without flux in a comparatively low vacuum degree. It was shown by experiments that Nickel, chosen as the base metal, could effectively improve residual stresses in brazing joints; the joint shear strength could reach up to more than 100MPa; a little active element Ti was found to distribute in the interfaces, which enhanced the interface reactions between ceramic and the metallizing layer.