Abstract:Due to non-condensable gas under conditions of vacuum and low temperatures, it becomes difficult to obtain precise vapor pressures of typical liquid desiccants by an experiment. Usually, non-condensable gas is removed by a traditional degassing method (degassing after prepared solutions - DPS), in which prepared liquid desiccants are circularly frozen and non-condensable gas is pumped out. However, the solvent of liquid desiccants could greatly evaporate during traditional degassing processes. Concentrations of the prepared liquid desiccants could be greatly deviated from those of the prepared liquid desiccants. Accordingly, measured vapor pressures usually greatly deviate from those corresponding to the concentrations of the prepared liquid desiccants. Moreover, it becomes very difficult to determine new concentrations of the prepared liquid desiccants after degassing, precisely. To overcome the challenges for precise measurements of typical liquid desiccants, a novel technique is developed in this context. The new method is called DSSPS (degassing solvents and solutes before preparing solutions - DSSPS), in which degassed solvent and solute is weighted respectively, and then, is mixed as measured solutions. Thus, concentrations of the measured solutions could be determined easily and precisely. Vapor pressures of LiCl-H2O desiccants are measured by the new method at a range from 218K to 258K and with the mass fractions of solutions from 5% to 20%. Totally, 35 sets of vapor pressure are measured. Then, the data is correlated based on Antoine equation. The ARD% (Absolute Relative Deviation - ARD) of equation is from 0.04% to 3.21% and AARD% (Average Absolute Relative Deviation - AARD) is 1.73%. So, the new method could be used to measure vapor pressure of aqueous solutions at vacuum and low temperatures precisely. The average error between experimental data and the results calculated by EES (Engineering Equation Solver - EES) is within 15.2%, and its maximum error is 35.46%. Vapor pressure data in this context also provides important reference for development of a precise calculation model.

Study on the Influence of Ambient Pressure on Liquid Density Transmission

The Measurement of Local Gas Holdup under High Superficial Velocity in Bubble Column

Study of analysis method of trace water in small-vessel gas at normal pressure

Development and Stability Verification of a Measuring Installation of Saturation Liquid Density

VAPOR PRESSURE MEASUREMNET OF LIQUID DESSICANTS AT LOW TEMPERATURES BY A NOVEL TECHNIQUE

Measurement Method of Compressibility Coefficient for Density Standard Liquid at 2329 Kg/M(3) with A Vibrating Tube Densimeter

Improvement on Liquid Saturated Vapor Pressure Measurement

Research on liquid flow standard facilities and automatic calibration systems

Vibrating tube densimeter for compressed liquid density measurement

The Reliability of Static Pressure Measurement With An Inertial Gas Gap Between Transducer and Viscous Slurries

Nondestructive Pressure Measurement in Vessels Using Rayleigh Waves and L-Cr Waves

Compressed Liquid Density Measurements of Dimethyl Ether with a Vibrating Tube Densimeter

Research on the Influence of Air Pressure to High Accuracy Mass Measurement

Relationship between fluctuating differential pressure and void fraction of gas-liquid two-phase flow in Venturi tube

Research on density measurement of liquefied natural gas storage tank based on computational fluid dynamics

Research on Pressure Measurement Model Using Surface Wave Considering Temperature Effect

The Novel Measurement Method of Liquid Level and Density in Airtight Container.

Experimental Study of Performance Parameters of a Fluid Densimeter with Vibrated Conduit

Study of Glass Hydrometer Calibration by Hydrostatic Weighting

Study on Uncertainty of Volume Measerment by Hydrostatic Weighing Method and Production of Calibration Medium

A METHOD FOR LIQUID VISCOSITY COEFFICIENT MEASUREMENT USING INCLINED TUBE