Force Transfer Model and Characteristics of Hybrid Transducer Type Ultrasonic Motors
Jf Guo,Sj Gong,Hx Guo,X Liu,Kh Ji
DOI: https://doi.org/10.1109/tuffc.2004.1295424
IF: 3.267
2004-01-01
IEEE Transactions on Ultrasonics Ferroelectrics and Frequency Control
Abstract:The characteristics of longitudinal-torsional hybrid transducer-type ultrasonic motors (HTUSM) are low speed and high torque. The discontinuous-surface-contact mode between the stator and the rotor is different from the many-point-contact mode of traveling wave motors, which is also an essential cause for high torque. Therefore, it is important to analyze its force transfer model between the rotor and the stator. In this paper, issues of using the method of equivalent circuit model are addressed. The relationships between the contact angle, preload, and physical parameters of frictional materials are given, according to the impulse conservation law axially. The equations describing output torque, amplitudes of longitudinal and torsional vibration, and parameters of the rotor are derived according to the principle that the work done by the load is equal to that by the driving force in one vibrating cycle. All factors that influence the mechanical characteristics are analyzed, and accuracy and suitability of the force transfer model are verified by comparison with the prototype motor. The formula for transfer efficiency on the stator/rotor interface is given, and the low-efficiency of this type motor is explained. The wide-working frequency range property of this type motor is shown with experimental results. Based on this study, the parameters of the rotor and preload are determined. The maximum torque of the prototype motor is up to 13.2 nm, and no-load speed of this type of motor is 12.5 rpm.