Effect of Al doping concentration on the structure and optical properties of zinc oxide nanorods

Yuxin WANG,Xiaowen CUI,Gudan ZANG,Wei ZHANG,Yong SONG,Zhen LI,Lei WANG,Shuai ZHAO
DOI: https://doi.org/10.3969/j.issn.1001-9731.2018.01.001
2018-01-01
Abstract:Al doping zinc oxide (ZnO:Al)nanorods with good photoluminescence which were made with the sputtering time of 15 min and the sputtering pressure of 0.7 Pa,were successfully synthesized by hydrothermal method with zinc oxide seed layer glass sheet as substrate.The crystal structural,surface morphology and pho-toluminescence properties of samples were measured by X-ray diffraction (XRD),scanning electron microscope (SEM)and photoluminescence (PL).XRD results indicated suitable Al doping made the growth direction of the zinc oxide nanorods along c axis (002)commendably,especially when the concentration ratio of Zn and Al was 1:0.02,the preferred orientation of zinc oxide nanorods along the c axis was the best.But in the case of in-creasing Al doping concentration,the selectivity became worse.SEM results showed that the crystal quality of zinc oxide nanorods decreased with the increase of Al content,and the top of the nanorods was becoming thin-ner,but the six angle structure still kept same.Photoluminescence showed that the band gap of zinc oxide was broadened by the incorporation of Al,and the near ultraviolet and blue luminescence properties of zinc oxide were improved.With the increase of the concentration of Al3+,the optical properties of the nanorods got better before they went poor.When the concentration ratio of Zn2+ to Al3+ was about 1:0.02,the optical properties of the nanorods are the best,meanwhile the intensity of the near UV emission light got maximum,and the blue shift occured.Different concentrations of Al doping had a certain impact on zinc oxide nanorods,and proper Al doping made the zinc oxide nanorods obtain better structure and optical properties.Meanwhile the application field of zinc oxide nanorods is broadened,which is very important for the production of optical devices.
What problem does this paper attempt to address?