Abstract:In this paper, a magnetic field-assisted WEDM-ECM complex process (MF-assisted WEDM-ECM) is proposed to solve the problems of traditional low-speed wire electrical discharge machining (WEDM-LS) of NiTi SMA, including low machining efficiency, high workpiece surface roughness, and large recast layer thickness. Electrolytic machining is used to remove the recast layer, and magnetic field-assisted method is used to reduce the surface roughness and improve the machining efficiency. Firstly, based on the double-layer model the removal thickness of recast layer is deduced, and the removal thickness of recast layer under different machining parameters is analyzed. In addition, based on the influence of magnetic field on discharge channel, the single spark crater analytical model is modified. Based on this model, combined with the electrochemical corrosion rate and the wire electrode vibration response equation, a continuous discharge corrosion mathematical model is established to predict the surface topography of the workpiece, and the simulation analysis is carried out. Finally, comparison of the experimental results of traditional WEDM-LS, MF-assisted WEDM-LS, ultrasonic vibration (USV)-MF complex-assisted WEDM-LS, and MF-assisted WEDM-ECM in machining NiTi SMA reveals that MF-assisted WEDM-ECM has the best machining performance. Compared with traditional WEDM-LS, the material removal rate (MRR) of MF-assisted WEDM-ECM was increased by 26.2%, the surface roughness value was reduced by 19.2%, and the thickness of recast layer was reduced by 44.25%. The average errors of the experimental and predicted values of workpiece surface roughness, recast layer removal thickness, and kerf width are 8.3%, 6.41%, and 3.58%, respectively, which verified the accuracy of the theoretical model proposed in this paper.

Magnetostrictive property and machinability of Terfenol-D rod

Modelling Self-Sensing of A Magnetostrictive Actuator Based on A Terfenol-D Rod

Optimization Design of Giant Magnetostrictive Micro High-Speed Valve Actuator

A Micro-Feed Actuator for Ultra-Precision Grinding of Brittle Materials

Research on Control Method for Machining Non-Cylinder Pin Hole of Piston

Machining principle for non-cylinder pin hole of piston based on giant magnetostrictive material

Linearity Hysteresis Model of Giant Magnetostrictive Components for Non-Cylindrical Hole Precision Machining

Experimental Study of High-Frequency Vibration Assisted Micro/Meso-Scale Forming of Metallic Materials

The Resonance Frequency Shift Characteristic of Terfenol-D Rods for Magnetostrictive Actuators

Effect of Terfenol-D rod structure on vibration performance of giant magnetostrictive ultrasonic transducer

Effect of magnetic-elastic-thermal coupling on the dynamic behaviors of Terfenol-D rods

Active Vibration Control of Terfenol-D Rod of Giant Magnetostrictive Actuator with Nonlinear Constitutive Relations

Numerical simulation on coupling behavior of Terfenol-D rods

Magnetostrictive Properties of Tbdyfe Alloys along the Direction Perpendicular to the Magnetic Field

Experimental Study on Magneto-thermo-mechanical Behaviors of Terfenol-D

Measurement and calculation for high frequency magnetic losses of Terfenol-D alloy rod under coupled stress and DC bias fields

Introduction of a novel longitudinal-flexural-torsional actuator using a magnetostrictive rod

A Nonlinear Constitutive Model For Terfenol-D Rods

Low eddy current loss of Terfenol-D/epoxy particulate magnetostrictive composites prepared using the particle phosphatizing treatment method

Effect of sub-micron deformations at opposing strain rates on the micromagnetic behaviour of non-oriented electrical steel

Study on removal of recast layer of NiTi shape memory alloy machined with magnetic field-assisted WEDM-ECM complex process