Abstract:Waterjet-assisted laser drilling technology facilitates the fabrication of high-quality micro-holes by utilizing the collaborative benefits of waterjets and lasers. In this study, the coaxial waterjet-assisted laser drilling (CWALD) technique was employed to improve the properties of micro-holes during femtosecond laser drilling. Based on computational fluid dynamics (CFD) simulations, the stability of the waterjet was initially verified by optimizing the structure of the watercourse and nozzle shape in the CWALD device. Furthermore, a comparative experiment between laser direct drilling (LDD) and CWALD revealed that while CWALD can produce well-rounded micro-holes with a high aspect ratio, it exhibits lower efficiency and results in a larger heat-affected zone (HAZ). To address these drawbacks associated with CWALD, a two-step coaxial waterjet-assisted composite laser drilling (TS-CWALD) method was proposed. TS-CWALD involves applying CWALD for secondary modification of micro-hole shape following LDD with punching. This modification process is pivotal for enhancing drilling accuracy but requires consideration of multiple parameters. For this purpose, regression models were established for the inlet diameter, outlet diameter, and taper; response surface methodology was then employed to optimize these parameters. Subsequently, interactive effects analysis was conducted on different responses based on laser pulse energy, frequency, modification speed, and number of modification cycles. The adequacy of the developed models was subsequently verified using analysis of variance methods. Finally, the successful fabrication of a film hole with an inlet diameter of 205 μm and an outlet diameter of 200 μm, featuring a taper of only 0.2°, was achieved ultimately through meticulous parameter optimization. Furthermore, the micro-hole retained a minimal HAZ. The optimized parameters encompassed a pulse energy of 20.6 μJ, frequency of 127 kHz, modification speed of 3 mm/s, and shape modification carried out over 335 cycles.

Structure Design of New Bi-stable Fluidic Amplifier for Liquid-jet Hammer

Flow characteristics simulation and low-noise design of fuel piston pump

Numerical Simulation of the Performance of the Sc-89 Jet Impact System

Structure Optimization of Hydraulic Press Based on FE Analysis

Structural Design of a Cross Wobble Plate Driving Axial Piston Pump Based on ADAMS and AMESim Co-simulation

Structure Innovation and Material Optimization of Annular Linear Induction Electromagnetic Pump Based on Temperature Field Constraints

The Optimization of Bellows Convolutions in Bellows Pump for Better Stress Distribution

Research on Multi-Objective Optimization of Low Pulsation Unloading Damping Groove of Axial Piston Pump

Flow Ripple Reduction of Axial-Piston Pump by Structure Optimizing of Outlet Triangular Damping Groove

Valve Plate Structural Optimal Design and Flow Field Analysis for the Aviation Bidirectional Three-Port Piston Pump

Effect of control flow on main jet switching for single and double feedback channels fluidic oscillator

Experimental investigation and optimization of modification during coaxial waterjet-assisted femtosecond laser drilling

Buffering the Backward Impact of Piston of Liquid-Jet Hammer

Study on the Structural Characteristics of Bulb Tubular Pumps Based on Fluid–Structure Interaction

Numerical Simulation and Optimum Design of Piston in GQ89 DTH Hammer

Structural design and effect analysis on a new type of hydraulic oscillator driven with double valve groups

Impact performance optimization for hydraulic rock drill based on stroke and flow compensation factors

The fluid-structure interaction response of composite auxetic re-entrant honeycomb structures to underwater impact

Optimized design of oil well pump plunger using bionic structure of decision system

On the optimal design of staved water-lubricated bearings driven by tribo-dynamic mechanism

Design optimization and feasibility analysis of pneumatic DTH Hammer with self-rotation bit