Production of Granular Iron with Waste Copper Slag

Zhi-jie SUN,Guo WEI,Zhan-hua LIU,Zhi-cheng CAO
DOI: https://doi.org/10.3969/j.issn.0253-6099.2017.05.019
2017-01-01
Abstract:Some experiments were conducted aiming at production of high-quality granular iron products by recycling iron resources in copper slag as much as possible. In the experiments, muffle furnace was used to simulate the laboratory condition of the rotary hearth furnace. Carbon-containing pellets prepared with copper slag, reduced coal and limestone, were subjected to a direct reduction roasting in a high-temperature furnace, with granular iron and slag obtained. The iron could be separated from slag by the following manual selection process. Influences of factors, including roasting temperature, roasting time, dosage of reduced coal and limestone on reduction effect, TFe grade of granular iron, iron recovery rate were all investigated. It is found that the following optimal processing parameters, including a mass ratio of copper slag, reduced coal and limestone at 100:20:10, a roasting temperature of 1400 ℃ and a roasting time of 40 min, can produce a high-quality granular iron with TFe grade of 94.72% at a recovery of 91.04%, with carbon content of 1.23%.
What problem does this paper attempt to address?