Abstract:With the composite insulator widely used on high voltage transmission lines in our country, the faults caused by its production craft, blemish in quality or aging increase gradually. Study of on-line detecting method for composite insulator is important for improve the safety of the power system. In this paper, on-line detection for composite insulator based on pulse current method is studied. It introduces the principle of the method, the constituent parts and the realization of the detecting system. The pulse current of an insulator is considered to be a good fingerprint of its insulation condition and the pollution severity at the installation site. So the pulse current method determines the condition of insulators by measuring the pulse current that through the earth wire. In this paper, a set of instrument which can on-line detect insulators condition on the ground is developed according to the pulse current method principle. In laboratory, using the founded measurement system, with the method of heightening voltage to simulate aging, the partial discharge impulse current characteristics of two different FXBW4-35/70 composite insulators have been studied. The results indicate that partial discharge impulses mainly occur between 60o~120o and 230o~300o in power frequency phrase, and the amplitude of impulse current, the number of the impulse and the phase scope where occurs increase along with the increase of the voltage. The result of the detection experiment to some practical running line insulators in Hunan electric power company tallies with the runtime of these composite insulators. The results indicate that this instrument has a good measure characteristic which can satisfy the need of on-line detecting composite insulator on the ground.

Insulation Resistance On- Line Detection of Coal Mine High Voltage Cable Based on DC Bridge Method

On-line Monitoring System for Underground 6 Kv Cable Networks in Coal Mine Based on Additional DC Measurement

Additional Low Frequency Signal Measurement Method Of Insulation Resistance About Mine Cable

On-line monitoring techniques for 10-35 kV XLPE cable

A novel distributing–collecting on-line insulation monitoring system and line selection technology for the DC supply system

Detection of Insulating Performance for Unarmored Cable under DC Leakage Current

Study on Online Insulation Detection for DC System Based on MT Technology

Investigation of On-line Monitoring Method on 1500 V Direct Current Cable of Subway

Fault Diagnosis Method for Neutral Grounding Three-Phase Bridge Type SSFCL

Study on Anti-interference Technique of On-Line Monitoring System for XLPE Cable's Sheathes

Design of Online Detection System for Insulation Resistance of Electric Vehicle Based on Unbalanced Bridge

Online Monitoring for Underground Power Cable Insulation Based on Common-Mode Signal Injection

Online Monitoring System of DC Feeder Cable for Urban Rail Transit

Application Research on Mine Rubber Cable Connection and Sheath Repair

Development of on-line monitoring system for insulation of high voltage electrical equipment

A New Type Integrated Device of DC Insulation Monitoring and Earth Point Locating

On-line Detecting System for Composite Insulators Based on Pulse Current Method

A Novel Online Monitoring Scheme for Underground Power Cable Insulation Based on Common-Mode Leakage Current Measurement

Research into a new type of on-line monitor for XLPE cable

Development of an On-line Monitoring System of 1.5 Kv DC Cable

A Cable Insulation Condition Detection Method Based on H-Bridge Cascading and Resonance