Abstract:For some new mines, the utilization rate of tailings is not satisfactory when using unclassified tailings as backfill aggregate for cemented backfill. At the same time, with the progress of mineral processing technology, the tailings discharged by the concentrator gradually become finer. Therefore, cemented filling with fine-grained tailings as aggregate will become the development direction of filling technology in the future. In this paper, the feasibility of fine particle tailings backfill is studied by taking the particle tailings of-200 mesh as aggregate in Shaling gold mine. The calculation shows that the utilization rate of tailings is increased from 45.1% to 90.3% by using-200 mesh tailings as filling aggregate. The response surface central composite design method (RSM-CCD) was used to study the strength of backfill with alkali-activated cementitious material as binder by taking the mass concentration of backfill slurry and sand-binder ratio as input factors. The results show that the 28-day strength of the backfill with graded fine-grained tailings as filling aggregate can reach 5.41 MPa when the sand-binder ratio is 4, which can fully meet the needs of the mine for the strength of the backfill. The thickening test of-200 mesh fine particle tailings was carried out by static limit concentration test and dynamic thickening test. In the case of adding 35 g/t BASF 6920 non-ionic flocculant, the concentration of 64.74% tail mortar can reach 67.71% after 2 h of static thickening, and the concentration can reach 69.62% after 2 h of static thickening. The feeding speed of thickener should be controlled between 0.4 and 0.59 t/(m2 h). In this case, the underflow concentration of thickener is relatively high, which is 64.92-65.78%, and the solid content of overflow water is less than 164 ppm. The conventional full tailings thickening process was improved by using the design of high-efficiency deep cone thickener and vertical sand silo. The feasibility of fine-grained tailings as filling aggregate was demonstrated by combining the filling ratio test of fine-grained tailings, the data of thickening test and the improved thickening process. The research results can provide reference for other mines to use fine-grained tailings as filling aggregate to design filling system.

Study on the New Granulation Technology for Heap Leaching of Gold Ore

STUDY ON GRANULATION AND HEAP LEACHING OF GROUND GOLD EXTRACTION TAILINGS

Copper sulfides agglomeration using a novel lab-scale granulator: Integrated evaluation of bonding, leaching and mechanical behavior

Experimental Research on Micro-disseminated Gold Ore Pretreated by Alkaline and Non-cyanide Leaching

Experimental Research on Refractory Gold Ore Pretreated by Grinding and Leaching Simultaneously with Non-cyanide

Status and Research of Leaching Technology of Gold Ore That is Difficult to Be Treated

Mechanism of synergistic pretreatment with eco-friendly CaO and Na 2 CO 3 to enhance gold leaching efficiency from fine-disseminated gold ores

Studies on Enhancing Leaching Process of Refractory Gold Ores by Mechanical Activation

Study on the Gold Leaching Process by Potassium Ferricyanide

Improvement Of Gold Leaching From A Refractory Gold Concentrate Calcine By Separate Pretreatment Of Coarse And Fine Size Fractions

New resource-saving technologies for gold recovery from rebellious and hard-to-process material of clayey deposits and mining waste

Research of the clean gold leaching in a gold-bearing acid residue thiourea system

Gold extraction from a low grade ore using the system of metal-ammonium-chloride-ammonia

Enhanced Hydrometallurgical Pretreatment of Micro-disseminated Gold Ore

Study on Characteristics of Leaching Gold from A Calcine of High-Arsenic and High-Sulfur Gold Concentrate

Research on Gold Extraction from a Refractory Gold Ore

Research on integrated technology in clean and non-waste utilization of gold concentration

Enriching gold from refractory gold concentrate by reducing sulfur-retention smelting

Experimental research on the flotation of a micro-fine particle refractory gold ore

Mineralogy And Pretreatment Of A Refractory Gold Deposit In Zambia

Study on strength characteristics and thickening characteristics of classified-fine cemented backfill in gold mine