Abstract:The usage of iron tailings as construction aggregates is a potential route to save the cost of standard sands and protect the environment of mining area. This study mainly investigates the performance of cement mortars by partial replacement of the standard sands (SS) with sulfide-contained iron ore tailings (IOT). The physicomechanical properties, microstructure, and hydration products were measured by consistency test, porosity test, strength test, P-wave velocity test, scanning electron microscopy test (SEM), and X-ray diffraction test (XRD). It is proven that the graded IOT (GIOT), which has an identical particle size distribution with SS, is better than the ungraded IOT to serve as fine aggregate by replacing SS because a suitable GIOT content can better reduce the adverse effect of excess fine tailings (<0.15 mm) and sulfide on the cement mortar. The graded tailings cement mortar (GTCM) by using GIOT has denser pore structure, lower porosity, higher strength, and P-wave velocity than ungraded tailings cement mortar (UTCM) by using UIOT at the same curing condition and age. In addition, although a high sulfide content (approximately 4.44% to 5.55% by weight) by adding more than 40% GIOT is conducive to reduce the porosity and improve the strength of GTCM before 28 days, it is harmful for the long-term performance beyond 90 days. The expansive ettringite and gypsum produced by the reaction of excess sulfide will cause microcracks and thus reduce the strength beyond 40% GIOT. To ensure the long-term performance of GTCM, the sulfide content in the aggregate should be controlled below 3% by weight, and the optimal substitution ratio of GIOT corresponding to this sulfide content is approximately 20% to 30%.

Research on Comprehensive Utilization of Low Grade Pyrite Cinder in South Sichuan

Recovery of iron from pyrite cinder by suspension magnetization roasting-magnetic separation method: Process optimization and mechanism study

Innovative methodology for the utilization of low-grade pyrite cinder containing heavy metals via hydrothermal alkali melting followed by chlorination roasting

Sintering test research with addition of hematite concentrate

Recovery of valuable elements from pyrite pyrolysis slag using magnetic separation-flotation technique

magnetic-separation Preparation of high quality magnetite concentrate from pyrite cinder by composite pellet reduction-roasting and

Utilization of Coal Gangue and Copper Tailings As Clay for Cement Clinker Calcinations

Mechanical Properties and Hydration Mechanism of Iron Tailings–Cement-Based Supplementary Cementitious Materials

Experimental Study on the Concrete with Compound Admixture of Iron Tailings and Slag Powder under Low Cement Clinker System

Experimental study on utilization of metallic tailings as cement mineralizer and iron raw material

Enrichment of iron element from sulfur-containing iron tailings by S-HGMS technology

Experimental Study on the Resource Utilization of Carbide Slag in Iron Ore Sintering Process

A Novel Method of Extracting Iron from High-Iron Red Mud and Preparing Low-Carbon Cement Clinker from Tailings

Study on Recovery of Iron and Sulfur from High-Sulfur Magnetite Ore

A Clean Disposal Method of Carbide Slag with Carbon Emission Reduction: Used As a Flux for Iron Ore Sintering

Innovative methodology for comprehensive utilization of iron ore tailings: part 2: The residues after iron recovery from iron ore tailings to prepare cementitious material.

Study on Separation of Iron from Waste Slag of Pyrite Processing

Experimental Investigation on the Performance of Cement Mortar by Partial Replacement of the Standard Sands with Sulfide-Contained Iron Tailings

Test research on the effects of mechanochemically activated iron tailings on the compressive strength of concrete

Recovery of Cu, Co, and Fe from Pyrite Cinder Based on Mineral Phase Reconstruction

Research on the Comprehensive Utilization of Cyanidation Slags of a Gold Smelter