Abstract:The low Seebeck coefficient and the high thermal conductivity deteriorate the thermoelectric properties of GeTe. Herein, the Seebeck coefficient is enhanced by promoting band convergency induced by the strongly correlated d, f electrons of rare earth elements. The doping of Pb and Bi causes avoided crossing and hierarchical structure, strengthening the full‐spectrum scattering of phonons and decelerating the sound velocity. As a highly promising thermoelectric material in the mid‐temperature region, pristine GeTe shows deteriorated thermoelectric properties due to the low Seebeck coefficient and the intrinsic high thermal conductivity. Herein, it is discovered that the introduction of strongly correlated d, f electrons by alloying rare‐earth atoms at Ge sites will increase the band effective mass and promote band convergency, which can largely improve the electric transport property. Moreover, the heavy atoms (Pb, Bi) doping induces optical phonon softening and the avoided crossing between acoustic and optical phonon branches, decelerating both optical and acoustic phonon velocities. The modulated composition wave from the fluctuated multi‐component distribution introduces a complicated hierarchical structure including point defects and nanoprecipitates, which provides all‐scale scattering sources for heat‐carrying phonons and results in low lattice thermal conductivity. Consequently, a high zT of 2.4 at 800 K can be obtained in the Ge0.86Pb0.09Bi0.03Ce0.005Te sample due to the combination of strong correlation for d, f electrons and the full‐spectrum scattering for phonons. This work provides an effective strategy to increase the thermoelectric performance of IV–VI compounds by combining the modulated band structure and the softening phonon dispersion.

Anion-site-modulated thermoelectric properties in Ge2Sb2Tes-based compounds

Anion-site-modulated Thermoelectric Properties in Ge 2 Sb 2 Te 5 -Based Compounds

Largely Enhanced Seebeck Coefficient and Thermoelectric Performance by the Distortion of Electronic Density of States in Ge2Sb2Te5

Anionic regulation and valence band convergence boosting the thermoelectric performance of Se-alloyed GeSb 2 Te 4 single crystal

Enhancing the Thermoelectric Performance of GeSb4Te7 Compounds via Alloying Se

Quasi-two-dimensional GeSbTe compounds as promising thermoelectric materials with anisotropic transport properties

Mid-temperature Thermoelectric Performance of Zone-Melted Sb2(Te,Se)3 Alloys Near Phase Transition Boundary

Modifying Roles of CuSbSe2 in Realizing High Thermoelectric Performance of GeTe

Crystal Symmetry Induced Structure and Bonding Manipulation Boosting Thermoelectric Performance of GeTe

Microstructures and Thermoelectric Properties of GeSbTe Based Layered Compounds

Thermoelectric Performance Optimization and Phase Transition of GeTe by Alloying with Orthorhombic CuSbSe 2

Optimized Carrier Concentration and Enhanced Thermoelectric Properties in GeSb4-xBixTe7 Materials

High Thermoelectric Performance Achieved in Sb-Doped GeTe by Manipulating Carrier Concentration and Nanoscale Twin Grains

Orchestrating phase transition in GeTe thermoelectrics: An investigation into the role of electronegativity

Improvement of the thermoelectric properties of GeTe- and SnTe-based semiconductors aided by the engineering based on phase diagram

Compositional Fluctuations Locked by Athermal Transformation Yielding High Thermoelectric Performance in GeTe

Realizing High Thermoelectric Performance in GeTe‐Based Supersaturated Solid Solutions

Functionally Separated Electronic Band Engineering Via Multi-Element Doping Plus High-Density Defects Advances Board-Temperature-range Thermoelectric Performance in GeTe

Synergistically Optimized Thermal Conductivity and Carrier Concentration in GeTe by Bi–Se Codoping

Structural modulation and resonant level enable high thermoelectric performance of GeTe in the mid-to-low temperature range

Achieving Superior Thermoelectric Performance in Ge4Se3Te Via Symmetry Manipulation with I–V–VI2 Alloying