Effect of austenite deformation on phase transformation behavior of 50CrV4 steel

DA Chuan-li,YANG Geng-wei,MAO Xing-ping,YU Chi-bin,HE Xian-ling,CAI Zheng

DOI: https://doi.org/10.13228/j.boyuan.issn1001-0963.20160314

2017-01-01

Abstract:The effect of austenite deformation on the continuous cooling phase transformation behavior and isothermal phase transformation behavior of 50CrV4 steel were systematically investigated by using of Thermecrnastor-Z thermal simulation testing machine,OM,SEM and Vickers hardness tester.The dynamic CCT curve of 50CrV4 steel was established.The results show that austenite deformation can promote ferrite-pearlite and bainite transformation during the continuous cooling process.And it also enhances the mechanical stability of austenite and inhibites the martensite transformation.While the Ms value decreases from 331.6 ℃ (Austenite non-deformation) to 291 ℃ (The specimens underwent 50％ engineering strain at 950 ℃ + 50％ engineering strain at 890 ℃,the strain rate is 5 s-1,and the cooling rate after deformation is 20 ℃/s.).When the cooling rate is lower than 0.5 ℃/s,the microstructure of ferrite and pearlite can be obtained in the experimental steel.Furthermore,the study on the effect of austenite deformation on isothermal phase transformation of tested steel shows that when the tested steel is held at 650 ℃,the transformation from austenite to ferrite and pearlite takes place.And when the deformation increases from 30％ to 50％,the isothermal phase transformation kinetics accelerate (The phase transformation completion time decreases from 197.6 s to 136.5 s),the grain size of ferrite and the interlamellar spacing of pearlite decreases,the hardness increases.