Austenitic continuous cooling transformation of V-N microalloyed forging steel used for automobile connecting rods made by splitting method

Xianzhong Zhang,Qingfeng Chen,Guifeng Zhou,Yuzhang Xiong,Qizhou Cai

DOI: https://doi.org/10.13251/j.issn.0254-6051.2015.08.008

2015-01-01

Abstract:Austenite continuous cooling transformation of V-N microalloyed forging steel used for automobile connecting rods made by splitting method was investigated by thermo-mechanical simulation experiments.The results show that phase transformation occurs from austenite to ferrite and pearlite at lower cooling rates, and with increasing cooling rates, pearlite content increases and grains are refined; however, at higher cooling rates, martensitic transformation occurs, its final microstructure is martensite.At the same time, V ( C, N) precipitated phases precipitate during continuous cooling transformation, and at lower cooling rates, the precipitated phase number is much and fine, but when the cooling rates increase to a certain value, the eutectoid transformation is inhibited, the second phase precipitation is restrained.