Abstract:The previous studies focus on the heat storage process of shell-and-tube latent thermal energy storage (LTES) under steady heat sources, without considering the fluctuating and intermittent characteristics of the most available heat sources in real applications. The effect of different fin sizes and locations on the charging performance of shell-and-tube LTES still keeps unclear under fluctuating heat source, and it is critical to improve the heat storage rate and density due to the low thermal conductivity of phase change materials (PCM). Consequently, this study aims to investigate the charging performance of a shell-and-tube LTES considering different fin layouts. Firstly, the effects of different fin number and configurations on heat storage process are performed under fluctuating heat sources. The case with comprehensive performance of high melting rate and large heat storage capacity is obtained. Then the effects of critical parameters on the charging process, including the fin angle, fin thickness, fin height and deviation distance of tube under fluctuating heat sources are further analyzed based on this case, and the results are compared with that of steady heat source. Results indicate that the fin height is the dominant factor influencing the heat storage rate and density under both steady and fluctuating heat source conditions, while the total melting time is shorter and the heat storage capacity is smaller, and the heat storage capacity is less obvious with the variation of fin parameters under the fluctuating heat source. In addition, the effect of downward deviation distance of tube on heat storage capacity is much obvious under fluctuating heat source than that of steady heat source.

Study on Fluctuation Characteristics of Instantaneous Temperature Field in Aluminum Electrolysis Pot for Wind Power Accommodation

Electrolytic Aluminum Load Participating in Power Grid Frequency Modulation Method Based on Active Adjustable Capacity Coordination

Effects of Fluctuating Thermal Sources on a Shell-and-tube Latent Thermal Energy Storage During Charging Process

Solid Oxide Electrolysis Cell under Real Fluctuating Power Supply with a Focus on Thermal Stress Analysis

Dynamic Behavior of High-Temperature CO2/H2O Co-Electrolysis Coupled with Real Fluctuating Renewable Power

Effects Evaluation of Fin Layouts on Charging Performance of Shell-and-tube LTES under Fluctuating Heat Sources

Parametric Study on Melting Process of a Shell-and-tube Latent Thermal Energy Storage under Fluctuating Thermal Conditions

Parametric Study on Dynamic Behaviours of Basic Organic Rankine Cycle Recovering Waste Heat with Thermal Power Fluctuations

Stray-current Corrosion of Aluminum Heat Sinks in Different Inner Water Cooling Systems for HV Converter Valves

Fully-Coupled Electric-Thermal-Flow Modeling and Investigation of Dynamic Thermal-Ledge Behavior in Aluminum Electrolysis Cell

Experimental Study on Stray-current Corrosion of Heat Sinks in Inner Cooling System of HV Converter Valves

Coupled Thermoelectric Model and Effects of Current Fluctuation on Thermal Balance in Magnesium Electrolysis Cell

Technology Research on Decreasing the Aluminum Surface Waves and Reducing the Cathode Voltage Drop in Aluminum Electrolysis Cell

Relationship Between Aluminium Electrolysis Current Efficiency and Operating Condition in Electrolyte Containing High Concentration of Li and K

Influences of various aluminum accumulation sump designs on thermal stress distribution in drained aluminum reduction cell

Effect of fluctuating temperature field on the sintering of Al–10Mg alloy

The Role Of Electric Current-Associated Free Energy And Forced Convection On Grain Refinement In Pure Aluminum Under Electropulsing

Study on Thermal Conduction Properties Improvement of Aluminum Potassium Sulfate

Monitoring And Analyzing Of Wall Temperature Fluctuations For Thermal Fatigue In Elbow Pipe

The Improved Thermal Conductivity of a Potting Material for High-Power Fast Warm-Up Cathodes

Analysis of 3D Thermo - Electric Field Potential for 300 Ka Aluminum Electrolysis Cell Using ANSYS