Abstract:Transactions of the Institute of Measurement and Control, Ahead of Print. The incorporation of converter-based generating sources in utility-scale microgrids causes frequency instability and low-frequency oscillations (LFOs), which is also a reason for degeneration in system stability. Damping frequency control is an essential part of alternating current (AC) microgrid system operation and control. Sudden changes in load, variations in renewable power outputs due to changes in solar insolation or wind speed, and so on factors cause the system frequency to deviate from the nominal value. Therefore, the role of a frequency controller is to maintain the dynamic stability in an AC microgrid by retaining the system frequency at the nominal value. Again, AC microgrids with high renewable power penetration face even more difficulty in maintaining frequency stability because of their poor inertial response. The research presented here proposes a novel approach for grid-connected AC microgrid oscillation damping and frequency control that simultaneously takes into consideration time delay and noise. To improve the frequency response and dampen LFOs by providing the voltage and frequency within the specified range, a coordinated technique-based control approach is adopted. In the developed hybrid control, the frequency controller relies on active power modulation, while the power oscillation damping controller is dependent on reactive power modulation. To improve stability and reduce communication consequences such as noise and signal latency (time delay), the developed power oscillation damping controller and frequency controller are coordinated along with the robust linear quadratic Gaussian controller. The comparative investigation of the effectiveness of the coordinated control technique is employed in the software of MATLAB/Simulink for grid-connected AC microgrid. The outcome of the simulation illustrates the superior effectiveness of the suggested controller over the traditional droop controller for huge power flows under disturbance with various operating conditions, under/overfrequency events, time delay, and noise. This grid encouragement capability for AC microgrids is anticipated to lead to novel possibilities for generating revenue.

Electrolytic Aluminum Load Participating in Power Grid Frequency Modulation Method Based on Active Adjustable Capacity Coordination

High-capacity Multi-level Emergency Load Shedding Technology for Electrolytic Aluminum Load

Multi-Process, Energy-Intensive Industrial Loads Participation in Demand Side Response Power Control Strategies

Load Modeling with Considering Frequency Characteristic

Frequency Characteristic of New-type Load Considering Power Electronics Technology

Online Damping Monitoring Approach Based on Disturbances of Traction Load and Its Application

Study On Peak Cutting And Valley Filling Based On Flexible Load

Load Support by Droop-Controlled Distributed Generations

Virtual Energy Storage Control Method of Electrolytic Aluminum Park Based on Production Data Driven

Modeling and Control of Flexible Loads for Frequency Regulation Services Considering Compensation of Communication Latency and Detection Error

Frequency Control by Aluminum Smelter Load Response in an Isolated Wind Power System: A Study for an Industrial Case

Hierarchical control of aluminum smelter loads for primary frequency support considering control cost

Forward Engineering of Local Load Control for Primary Frequency and Voltage Regulation

Research and Application of Power Grid Maintenance Scheduling Strategy under the Interactive Mode of New Energy and Electrolytic Aluminum Load

Simultaneous Damping and Frequency Control in AC Microgrid Using Coordinated Control Considering Time Delay and Noise

Research on Real-Time Dynamic Allocation Strategy of Energy Storage Battery Participating in Secondary Frequency Modulation of Distribution Network

Consumer Electrical Equipment Asynchronous and Coordinating Response for Frequency Regulation

Load frequency control of new energy power system based on adaptive global sliding mode control

Mixed Variable Parameter Energy Storage-Assisted Frequency Support Strategy

Demand Side Frequency Control Scheme in an Isolated Wind Power System for Industrial Aluminum Smelting Production

Capacity Configuration of Hybrid Energy Storage Power Stations Participating in Power Grid Frequency Modulation