Abstract:Temperature has a great influence on the mechanical properties of ductile cast iron or nodular cast iron. A thermomechanical treatment was carried out at various elevated temperatures of 450 °C, 750 °C and 850 °C using a universal testing machine with a tub furnace. Specimens were held at these temperatures for 20 min to ensure a homogeneous temperature distribution along the entire length of the specimen, before a tensile load was applied. Specimens were deformed to various levels of uniform strain (0%, 25%, 50%, 75%, and 100%). These degrees of deformation were measured with a dial gauge attached to a movable cross plate. Three strain rates were used for each specimen and temperature: 1.8×10−4 s−1, 9×10−4 s−1 and 4.5×10−3 s−1. A simple analytical model was extracted based on the CT tensile test geometry and yield stress and a 0.2% offset strain to measure the fracture toughness (JIC). To validate the analytical model, an extended finite element method (XFEM) was implemented for specimens tested at different temperatures, with a strain rate of 1.8×10−4 s−1. The model was then extended to include the tested specimens at other strain rates. The results show that increasing strain rates and temperature, especially at 850 °C, increased the ductility of the cast iron and thus its formability. The largest percentage strains were 1 and 1.5 at a temperature of 750 °C and a strain rate of 1.8×10−4 s−1 and 9×10−4 s−1, respectively, and reached their maximum value of 1.7 and 2.2% at 850 °C and a strain rate of 9×10−4 s−1 and 4.5×10−3 s−1, respectively. In addition, the simple and fast analytical model is useful in selecting materials for determining the fracture toughness (JIC) at various elevated temperatures and different strain rates.

Investigation on Low-Temperature Impact Toughness of Heavy-Section Nodular Iron

Mechanism Analysis for the Enhancement of Low-Temperature Impact Toughness of Nodular Cast Iron by Heat Treatment

Investigation on Detection Method for Ductile-brittle Transition Temperature of 400-18LT Ductile Iron

EXPERIMENTAL STUDY ON THE IMPACT TOUGHNESS OF Q460-C HIGH-STRENGTH CONSTRUCTION STEEL AT LOW TEMPERATURE

Effect of the Austenitizing Temperature on Microstructure Evolution and Impact Toughness of a Novel Bainite Ductile Iron

Research On Impact Toughness Of Q460c High-Strength Steel At Low Temperature

Testing the Impact Resistance of Thick Structural Steel Plate at Low Temperatures

Low temperature impact toughness of high strength structural steel

Influence of Working Conditions and Blank Sizes on Low Temperature Impact Properties of 35CrMo Steel

Microstructures and impact toughness of low-alloy high-carbon steel austempered at low temperature

Microstructural Characteristics and Impact Fracture Behaviors of Low-Carbon Vanadium-Microalloyed Steel with Different Nitrogen Contents

Research into Fracture Behavior of Mild Steel in Crack-Like Notch Impact Test

Experimental study on mechanical properties and impact toughness of steel for transmission line towers at low temperatures

Analysis of the Impact Toughness Test and Fracture of Rail Thermit Welding Joints at Low Temperature

Experimental Study on the Through-Thickness Properties of Structural Steel Thick Plate and Its Heat-Affected Zone at Low Temperatures

Mechanical Properties and Fracture Toughness Prediction of Ductile Cast Iron under Thermomechanical Treatment

Study of low-temperature impact deformation behavior of Ti–6Al–4V alloy

Low-Temperature Impact Property of 0Cr17Mn17Mo3NiN AusteniticStainless Steel after Cryogenic Treatment

Experimental Study on the Impact Toughness of Thick Plate Butt Weld of Steel Structure at Low Temperature

Impact Property of 20simn2mov Steel at Low Temperature

Cryogenic Toughness in a Low-Cost Austenitic Steel