Abstract:The thread and spline synchronous rolling (TSSR) process is a new developed rolling process, which can form the different profiles simultaneously in the process and can ensure the consistency of the relative position of different profiles of parts. However, the multi-meshing motions are intercoupling and the multi-deformation characteristics are intercoupling during the forming process. It can easily result in dimension overshoot, and even does not make the synchronous rolling process go smoothly. Exploring the influence of controllable processing parameters on the synchronous rolling process, especially the geometric parameters of rolled parts, is helpful to determine the parameters and control the size error for a smooth rolling process. Thus, in this paper, the effects of controllable geometric parameters and motion parameters such as billet diameter, radial feed-in speed, and rotational speed of synchronous rolling die on the TSSR process have been studied. The synchronous rolling experimental scheme was determined using an orthogonal experimental design method, and the geometric parameters of different tooth profiles of rolled parts were measured and analyzed. The experimental results indicated that: the uncoordinated meshing movement between different tooth profiles is more likely to cause tooth error of the splined section of the part; variations of the processing parameters are more likely to cause fluctuations in the size of the splined section of the part, and change of the billet diameter mainly affects the outside diameter of the threaded and splined sections, and the threaded and splined pitches are mainly affected by the motion parameters of the synchronous rolling die; the motion parameters of the rolling die should be matched and the lower rotational speed needs to match the lower radial feed-in amount per revolution; the ideal dimensional accuracy can be obtained by using an appropriate processing parameter combination, for example, the pitch error of the splined section of the part is less than 0.5 μm under one set of experimental conditions in this paper.

The Influence of Roller Motion on Profile and Hardness of T2 Worm

Influence of roller motion modes on rolling forming of reducer worm

A Novel Multipass Incremental Gear Rolling Process with Blank and Rolling Die Axes Crossed

Study on the defect reduction of metal folding on the formed tooth top with finishing roller in gear rolling process

A Hybrid of Theory and Numerical Simulation Research for Virtual Rolling of Double-Groove Ball Rings

Analysis of Motion Between Rolling Die and Workpiece in Thread Rolling Process with Round Dies

Theoretical modeling and transmission characteristics analysis of a novel double-roller hourglass worm drive based on enveloping principle

Experimental and numerical investigations on the deformation defects by gear rolling process with local induction heating

Study on the tooth profile and meshing equation of the anti-backlash double-roller enveloping hourglass worm with errors

Influence of Processing Parameters on the Thread and Spline Synchronous Rolling Process: an Experimental Study.

Meshing principle and geometry of tooth profile for offset enveloping cylindrical worm drive

Numerical Simulation of Influence of Roller Working Surface on Spin-Forming of Rectangular Inner Meshing Gear

Performance Improvement and Parameter Influence of Thread Shaft by Axial Self-infeed Rolling Process

Parametric Study of Meshing Characteristics With Respect to Different Meshing Rollers of the Antibacklash Double-Roller Enveloping Worm Gear

The Study and Analysis of a New Anti-backlash Worm Gear

A Novel Precision Grinding Method for Roller Enveloping Hourglass Worm

Mechanical Properties Analysis of Cylindrical Roller Bearings with Different Profiles under Combined Load

Meshing theory and tooth profile geometry of toroidal surface enveloping conical worm drive

The Importance of Forming Parameters on Rolling Process and the Performances of Component in Forming Long Threads

Analysis of Thread Rolling Process Using an Analytical Single Tooth Rolling Model Based on the Slip Line Field Theory and Slab Method

A new method of rolling finishing forming process of spiral bevel gears investigated by numerical simulation and experiment