PDMS Surface Modification Parameters Based on UVO Irradiation

Ya-ya ZHANG,Jian-guo CUI

DOI: https://doi.org/10.16490/j.cnki.issn.1001-3660.2016.03.015

2016-01-01

Abstract:ABSTRACT:Objective Polydimethylsiloxane ( PDMS) was developed as commonly used polymer materials in microfluidic chip, and its own hydrophobic properties was a major obstacle that affects the overall chip bonding effects. In order to achieve effective bonding and packaging between PDMS and the substrate materials within a short time, a low-cost and highly efficient PDMS materi-al modification method that could be performed in ordinary laboratories was designed. Methods Ultraviolet ozone( UVO) irradiation method was used to study PDMS surface modification, and the orthogonal experiment method was used to study the influences of UV irradiation time, distance and oxygenation time on the PDMS surface modification effects. The bond strength between PDMS sub-strate and the cover sheet ( PDMS or glass) was measured in 50 ℃ water bath at different times, and finally the optimal combina-tion of the parameters was determined. Results Compared with the traditional surface modification method of ultraviolet irradiation with a bonding time of more than 50 h, the proposed process could successfully implemented PDMS packaging within six hours. And the P—P and P—G′s optimal parameters combination was finally determined, with both average bonding strengths of greater than 200 kPa. Conclusion The whole process was simple and low-cost, and could be used as a useful supplement to microfluidic experimental research in ordinary laboratories.