Abstract:Purpose To fabricate a selective laser melting (SLM)-processed AlSi10Mg part with almost full density and free of any apparent pores, this study aims to investigate the effect of ambient argon pressure and laser scanning speed on the particles splash during the AlSi10Mg powder bed laser melting. Design/methodology/approach Based on the discrete element method (DEM), a 3D model of random distribution of powder particles was established, and the 3D free surface of SLM forming process was dynamically tracked by the volume of fluid, where a Gaussian laser beam acts as the energy source melting the powder bed. Through the numerical simulation and process experimental research, the effect of the applied laser power and scanning speed on the operating laser melting temperature was studied. Findings The process stability has a fundamental role in the porosity formation, which is process-dependent. The effect of the processing conditions on the process stability and the resultant forming defects were clarified. Research limitations/implications The results shows that the pores were the main defects present in the SLM-processed AlSi10Mg sample, which decreases the densification level of the sample. Practical implications The optimal processing parameters (argon pressure of 1,000 Pa, laser power of 180 W, scan speed of 1,000 mm/s, powder layer thickness of 35 µm and hatch spacing of 50 µm ) applied during laser melting can improve the quality of selective laser melting of AlSi10Mg, Social implications It can provide a technological support for 3D printing. Originality/value Based on the analysis of the pore and balling formation mechanisms, the optimal processing parameters have been obtained, which were argon pressure of 1,000 Pa, laser power of 180 W, scan speed of 1,000 mm/s, powder layer thickness of 35 µm and hatch spacing of 50 µm. Then, a near-fully dense sample free of any apparent pores on the cross-sectional microstructure was produced by SLM, wherein the relative density of the as-built samples is larger than 97.5%.

Analysis on Powder Adhesion Problems in Selective Laser Melting Forming Process

Adhesion Effects on Spreading of Metal Powders in Selective Laser Melting

Effects of the processing parameters on the forming quality of stainless steel parts by Selective Laser Melting

Numerical Study of the Pore Defects Formation Mechanisms in Selective Laser Melting Process

Study on the Technique During Selective Laser Melting of Stainless Steel Powder

Effect of Processing Parameters on Forming Defects During Selective Laser Melting of AlSi10Mg Powder

Influence of powder characteristic and process parameters on SLM formability

Study on SLM fabrication of precision metal parts with overhanging structures

Optimization of Molten Metal Line Morphology in Selective Laser Melting

Research on Direct Rapid Manufacturing of Metal Part based on Flexible Powder Spreading Mechanism

Balling Phenomenon in Selective Laser Melting Process

Thermal Behavior and Densification Mechanism during Selective Laser Melting Additive Manufacturing of Metal Powder

Density Improvement of Metal Parts Directly Fabricated via Selective Laser Melting

Study on the Effects of Powder Properties on the Performance of Stainless Steel Parts Produced by Selective Laser Melting

Formation Mechanism of Adhering Powder and Improvement of the Surface Quality During Laser Solid Forming

Experimental and computational study on thermal and fluid behaviours of powder layer during selective laser melting additive manufacturing

Direct Manufacturing of Cu-based Alloy Parts by Selective Laser Melting

Coupling Analysis on Microstructure and Residual Stress in Selective Laser Melting (SLM) with Varying Key Process Parameters

Investigation into the shrinkage in Z-direction of components manufactured by selective laser melting (SLM)

Effect of SLM Process Parameters on Relative Density of Maraging Steel (18Ni-300) Formed Parts

Densification Behavior of Gas and Water Atomized 316l Stainless Steel Powder During Selective Laser Melting