Abstract:Grain refinement of Zr–containing Al alloys has attracted extensive attention for many years in both industry and academia, since "Zr–poisoning" phenomenon always happens when commercial refiner is applied in such alloys. This unrecoverable grain nucleating obstacle finally leads to poor grain refinement efficiency. In this work, a special Al–Ti–C master alloy rich in TiC nano–particles was applied to a high–strength Al–Zn–Mg–Cu–Zr alloy (i.e. 7050 alloy). The effects of TiC nano–particles on the microstructure and mechanical properties of 7050 alloy during solidification, hot extrusion and subsequent heat treatment were systematically investigated. The results show that prominent grain refinement occurs with TiC addition through both the growth restriction effect and heterogeneous nucleation. Meanwhile, TiC nano–particles are more inclined to distribute along grain boundaries than the interior of matrix grains after solidification. After subsequent homogenization and hot extrusion, TiC nano–particles tend to align along extrusion direction. In comparison with 7050 matrix alloy, the tensile properties especially ductility of 1% TiCp/7050 composite after heat treatment have been improved obviously. Furthermore, it is worth noting that precipitates in the composite have also been obviously refined. Synergetic effects of grain refinement, refined precipitates and increased dislocation density are responsible for the optimized mechanical properties of TiCp/7050 composite. This work provides new insights for controlling matrix grains of Zr–containing Al alloys and developing low–cost Al matrix composites.

Progress of Study of Al-Ti-C Master Alloy

STUDY ON THE MICROSTRUCTURES AND GRAIN REFINING PERFORMANCE OF Al-Ti-C GRAIN REFINING MASTER ALLOYS

Recent Development in Research of AlTiC Master Alloy

The Behavior of AlTiC Master Alloys in Grain Refining of Commercial and High Pure Aluminum

Preparation Process and Phase Transformation of Al-5Ti-0.25C Master Alloy Adopting Ti Machining Chips

Research Progress of Al-Ti-B Grain Refiner

Performance Comparison of AlTiC and AlTiB Master Alloys in Grain Refinement of Commercial and High Purity Aluminum

Alloying Design of Titanium Aluminum Intermetallics and Research Progress

Grain refinement of A356 alloy by Al–Ti–B–C master alloy and its effect on mechanical properties

Research of Grain Refining on Pure Al by Three Different Master Alloys

Aluminothermal Reaction to Prepare Al-Ti-C Master Alloy

Influences of Preparation Conditions and Melt Treatment Procedures on Melt Treatment Performance of Al-5Ti-B and Al-10Sr Master Alloys

Study on the Microscopic Mechanism of the Grain Refinement of Al-Ti-B Master Alloy

Study on Grain Refining and Metamorphism of ZL111 Aluminium Alloys

Enhanced grain refinement and mechanical properties of a high–strength Al–Zn–Mg–Cu–Zr alloy induced by TiC nano–particles

On the Understanding of Aluminum Grain Refinement by Al-Ti-B Type Master Alloys

Microstructure And Grain Refining Performance Of A Rapidly Solidified Al-5ti-1b Master Alloy

A new insight into heterogeneous nucleation mechanism of Al by non-stoichiometric TiCx

The Grain Refinement of 1070 Alloy by Different Al-Ti-B Mater Alloys and Its Influence on the Electrical Conductivity

Grain refining performance of Al–Ti master alloys with different microstructures

The Evaluating Study of the Refining Effect of Al-Ti-C and Al-Ti-B on Aluminum