Mold Filling and Solidification of Bimetal Roller Sleeve for Coal Grinding Mill During Centrifugal Composite Casting Process

Qin XU,Xing WANG,Xueji HU,Shiping WU,Yan WANG

DOI: https://doi.org/10.16410/j.issn1000-8365.2017.12.041

2017-01-01

Abstract:The mould filling and solidification of duplex metal roller sleeve for the coal grinding mill during centrifugal composite casting process had been simulated by the ProCAST simulation software.The outer layer of the roller sleeve was produced by horizontal centrifugal casting process.When calculating,the 3D model had no gating system,and the sprue was set on the inner surface of the outer layer of the roller sleeve.The rotating shaft was set to be perpendicular to gravity.The inner layer of the roller sleeve was produced by gravity casting process,and the sprue was set at the small-diameter end of the roller sleeve.The results show that the outer layer metal show that the liquid metal first reach the big-diameter end at the direction opposite to the rotating shaft.And then the metal separate into two different streams and fill the big-diameter end of the casting mould.After that the two streams join together and fill the mould in spiral shape.The solidification process of the outer layer metal show that the temperature decreases from the outside to the inside.The simulate results of inner layer metal show that the liquid metal first reach the big-diameter end at the bottom of the mould.And then the metal separate into two same streams and evenly fill the big-diameter end.After that the two same streams join together and the liquid surface rise steadily until it fulfills the whole mould.