Abstract:The high-speed rotating superconducting rotor can be used as high-precision inertial devices to measure the angular position or angular velocity of the carrier. The mass eccentricity and spherical error of the superconducting rotor are the main error sources that affect the measurement accuracy. The more complex the structure of superconducting rotor, the greater the mass eccentricity and spherical error caused by its production and assembly process, and the lower the accuracy of its measurement of angular velocity. Based on this, this article designs a electromagnetic drive structure with a simple rotor structure. And the torque generated by the stator on the superconducting rotor was studied through finite element method (FEM). The effect of stator on vertical alignment and acceleration of the superconducting rotor was analyzed. Based on the research results of superconducting rotor torque, a superconducting rotor drive method with integrated driving and alignment drive is proposed, which achieves the driving and alignment functions simultaneously through the stator coil, and corresponding stator control timing is designed. Finally, the torque distribution during the driving process of the proposed driving method was analyzed, and the driving effect was quantitatively analyzed based on the response characteristics of the stator system. The time for the superconducting rotor to accelerate to 50Hz under different conditions was calculated. The results indicated that the designed driving electromagnetic structure and the proposed integrated driving method of alignment and driving can be used for the vertical alignment and driving of superconducting rotor. The research results provide reference for further optimizing the superconducting rotor structure and driving methods of superconducting rotors.

The Simulation Design and Experimental Research on Key Parts of Trajectory Correction Device

Multi-Structural Optimization of Bearingless Permanent Magnet Slice Motor Based on Virtual Prototype in Ansoft Maxwell

Model Building and Intelligent Programming System for Electric Motor Armatures Automated Balance Correction

Error Modeling and Compensation of Circular Motion on a New Circumferential Drilling System

Simulation Analysis of a Novel Magnetic Gear

The Design and Aerodynamic Characteristics Analysis on Resistance-increasing One-dimensional Trajectory Correction Mechanism

Design for Mechanical Structure of Asynchronous Motor Principle Experiment Device

Design of New One-dimensional Trajectory Correction Mechanism

The Reconstructive Design of the Orbit-Retractor-brake-device

Research on trajectory correction model of dual magnetic navigation differential mobile robot

Design and Analysis of a Linear-Rotary Permanent Magnet Motor with Orthogonal Windings

Active Vibration Control of a Flexible Rotor in Magnetically Suspended High-Speed Motor to Pass the First Bending Critical Speed with Optimal Phase Compensation Control

Kinematics Simulation And Experimental Verification Of Rotational-Yaw Mechanism Under Impulsive Force

Research on High Precision Drive System of Permanent Magnet Synchronous Motor

Controller Design of a Supercritical High Speed Motor System Suspended by Active Magnetic Bearings

A Study on the Friction of a Self-Correction Ultrasonic Stepping Motor

Research on Superconducting Rotor Drive Method with Integrated Driving and alignment

Study on dynamic characteristics of acceleration process of spherical hybrid sliding bearings rotor system

A Study of the Driving Circuit in Multi-Degree-of-Freedom Ultrasonic Motor for Trajectory Correction

Kinematics Analysis and Trajectory Planning of Force Feedback Device

Error Compensation Trajectory Planning Method of Brake Disc Shaft Hole Assembly Considering Robot Accumulated Error