Abstract:A rotor system supported by active magnetic bearings (AMBs) is actually a second-order dynamical system, whose dynamical characteristics should be considered in the design process of the controller. The relationships between the dynamical parameters and the control parameters can be established by the eigenstructure assignment. Output feedback dynamical compensators (OFDCs) are proposed based on the eigenstructure assignment for an AMBs-rigid rotor system in this article. First, the model of the four-degree-of-freedom AMBs-rigid rotor system was established, and it was decoupled into two single-degree-of-freedom (S-DOF) translational sub-systems and two S-DOF rotational sub- systems through the modal decoupling method. Aiming to the control of the four S-DOF systems, the relationships among the parameters of the OFDCs, the eigenvalues, and the eigenvectors were derived based on the eigenstructure assignment. Then, a multiobjective optimization problem was constructed in which the system stability, the robustness to the bias current perturbation, and the maximum amplitudes of the unbalance displacement and control current were considered. Several Pareto solutions were obtained through NSGA-II, and different solutions were selected to compare the performance of the corresponding systems. The simulation and experimental results verify the effectiveness of the proposed OFDCs and the rationality of the proposed design process.

Controller Design of a Supercritical High Speed Motor System Suspended by Active Magnetic Bearings

Multi-Objective Optimal Design of Μ–controller for Active Magnetic Bearing in High-Speed Motor

Modeling and Realization of Multiphase Permanent Magnet Synchronous Motor Variable Speed System

Active Vibration Control of a Flexible Rotor in Magnetically Suspended High-Speed Motor to Pass the First Bending Critical Speed with Optimal Phase Compensation Control

Vibration Control for Active Magnetic Bearing High-Speed Flywheel Rotor System with Modal Separation and Velocity Estimation Strategy

Controller Design for a Flexible Rotor Supported by Active Magnetic Bearing Passing the Critical Rotational Speed

Active Vibration Control of a Non-collocated AMBs Flexible Rotor System to Pass the First Bending Critical Speed

Modal decoupling control for active magnetic bearing-supported flywheel rotor system

Decoupling Control for Active Magnetic Bearing High-speed Flywheel Rotor Based on Mode Separation and State Feedback

High Speed Motor Supported by Active Magnetic Bearings with High Nonlinearity

The Effect of Controllers on the Dynamic Behaviour of a Rotor Supported on Active Magnetic Bearings

Current Compensation Control of Multiple Frequency Vibrations of the Rotor in Active Magnetic Bearing High Speed Motors

Rotor Vibration Control for Magnetic Suspended High-Speed Flywheel Energy Storage System with Inverse System Method and Extended 2-DOF PID Controller

Novel Decoupling Control and Eigenstructure Assignment Strategies for Rigid Active Magnetic Bearing Rotor System

The Dynamics of a Cracked Rotor with an Active Magnetic Bearing

Analysis of supercritical pitchfork bifurcation in active magnetic bearing-rotor system with current saturation

Principle And Realization Of A 5-Phase Pm Bearingless Motor Drive

Output Feedback Dynamical Compensation Via EigenStructure Assignment for Active Magnetic Bearings-Rigid Rotor Systems.

Robust Proportional-Differential Control Via Eigenstructure Assignment for Active Magnetic Bearings-Rigid Rotor Systems

Vibration Control of an Active Magnetic Bearings Flexible Rotor System Based on Adaptive Recursive Least Square Algorithm

Analysis and Control of Seven-Phase Permanent-Magnet Bearingless Motor with Single Set of Half-Coiled Winding.