Abstract:Existing vibration displacement control strategies in active magnetic bearing (AMB) flexible rotor systems suffer from a trade-off between damping and noise, which makes it difficult for the system to pass the critical speeds of bending modes. To solve this problem, a rotor vibration velocity and acceleration feedback control strategy based on a non-contact velocity sensor technique is proposed in this paper. The non-contact rotor vibration velocity sensor uses the induced electromotive force caused by changes in the air gap reluctance to measure the rotor vibration velocity. First, an analytical model of the sensor was developed and validated by the finite element method. Then, the structure of the vibration velocity and acceleration feedback control was proposed. Analytical and numerical calculations demonstrated that the rotor vibration velocity feedback is more effective for low-frequency vibrations, whereas the acceleration feedback is utilized to deal with resonances of higher-order bending modes and the weak controllability of the rotor system. To avoid excessive control gains at high frequencies, the least mean square algorithm was adopted to extract the synchronous components of the acceleration. Finally, the experiments were carried out in the AMBs flexible rotor test setup. The results showed that the vibration velocity sensor can be used to assist the proportional–integral–derivative controller to obtain extra damping without significantly increasing the current noise. Low-frequency vibrations were significantly reduced by damping from the rotor vibration velocity feedback. The vibrations at the critical speed of the 2nd bending mode were substantially suppressed by the rotor vibration acceleration feedback.

Controller Design for a Flexible Rotor Supported by Active Magnetic Bearing Passing the Critical Rotational Speed

Vibration Control for Active Magnetic Bearing High-Speed Flywheel Rotor System with Modal Separation and Velocity Estimation Strategy

Vibration Control of an Active Magnetic Bearings Flexible Rotor System Based on Adaptive Recursive Least Square Algorithm

Study on Active Magnetic Bearing Controller for HTR-10 Helium Turbine Rotor

Dynamic Analysis Of Flexible Rotor Suspended By Active Magnetic Bearings With Lqr Controller

Active Vibration Control of a Non-collocated AMBs Flexible Rotor System to Pass the First Bending Critical Speed

Multi-Objective Optimal Design of Μ–controller for Active Magnetic Bearing in High-Speed Motor

The Design of the Robust Controller for Active Magnetic Bearings on Active Disturbance Rejection Technology

Robust Proportional-Differential Control Via Eigenstructure Assignment for Active Magnetic Bearings-Rigid Rotor Systems

Sliding Mode Control Based on Linear Quadratic Regulator for an Active Magnetic Bearing Flexible Rotor Virtual Collocated System

Rotor Vibration Control for Magnetic Suspended High-Speed Flywheel Energy Storage System with Inverse System Method and Extended 2-DOF PID Controller

Active Control of Active Magnetic Bearings for Maglev Flywheel Rotor System Based on Sliding Mode Control

The Effect of Controllers on the Dynamic Behaviour of a Rotor Supported on Active Magnetic Bearings

Output Feedback Dynamical Compensation Via EigenStructure Assignment for Active Magnetic Bearings-Rigid Rotor Systems.

Vibration of Flexible Rotor Systems with Two-Degree-Of-Freedom Pid Controller of Active Magnetic Bearings

Decoupling Control for Active Magnetic Bearing High-speed Flywheel Rotor Based on Mode Separation and State Feedback

Multiobjective Vibration Control for the Noncollocated Active Magnetic Bearings Flexible Rotor Systems

Novel Decoupling Control and Eigenstructure Assignment Strategies for Rigid Active Magnetic Bearing Rotor System

Internal model control for the AMB high-speed flywheel rotor system based on modal separation and inverse system method

ICONE11-36524 PRELIMINARY MODAL ANALYSIS AND STRUCTURE DESIGN OF AN HTR-10 PCU ROTOR WITH AN ACTIVE MAGNETIC BEARING

Non-contact Rotor Vibration Velocity Sensor and Its Application to Vibration Control of a Flexible Rotor on Active Magnetic Bearings