Abstract:With the raise of resolution, optical payloads are becoming increasingly sensitive to satellite jitter. An approach where the entire spacecraft is pointed with great accuracy requires sophisticated and expensive bus design. In an effort to lower the overall cost of space missions that require highly stable line-of-sight pointing, a method of separating the bus and the payload with low frequency isolators is proposed. This isolation system can block the transmission of disturbance and allow relatively large bus motion. However, if the isolator is linear then there is a trade-off between isolation and static deflection as the launch and the on-orbit stage have difference requirements on the isolation frequency. Otherwise, an extra locking system should be appended to protect the payload before getting into orbit, as the STABLE isolation system[1] and the MIM isolation system[2] did. To overcome this limitation, an alternative approach is to design a nonlinear isolator with high-static stiffness during launch and low dynamic stiffness on orbit. Several specially designed nonlinear isolators have achieved low dynamic stiffness with large static load capacity. Virgin[3] considered a structure made from a highly deformed elastic element to achieve a softening spring. Platus[4] exploited the buckling of beams under axial load in a specific configuration to achieve a negative stiffness in combination with a positive stiffness, and hence low-dynamic stiffness. Others have achieved the same by connecting linear springs with positive stiffness in parallel with elements of negative stiffness[5]~[7]. In the present study, a bifunctional isolator has been developed for optical payloads. The isolator have good performance both during launch and on orbit because of its specially designed nonlinear stiffness and damping. The isolator works in a linear part with low stiffness and small damping ratio under the micro-vibration and microgravity on orbit. The transmissibility requirement and the displacement restriction during launch are satisfied by tuning the nonlinear stiffness and damping parameters. A group of sample isolators are designed tested both statically and dynamically.

Optimization Design of the Whole-Spacecraft Isolation System

Simulation And Design Of Composite Vibration Isolator For Spacecrafts

Application Research of Genetic Algorithm on the Whole-Spacecraft Vibration Isolation System

Research on Passive Isolation Characteristics and Rocket-spacecraft Coupling of a New Whole-spacecraft Isolation Platform

Measurement for the Dynamic Character of the Whole-Spacecraft Isolator

Performance Analysis of the Whole-Spacecraft Isolator

A Composite Optimization Method for Separation Parameters of Large-Eccentricity Pico-Satellites

Analytical Study of Whole Flexible Spacecraft Vibration Isolation

Review of the Whole-spacecraft Isolation Techniques

Performance Analysis of the New Whole-Spacecraft Isolator

Passive Control Design of Whole-spacecraft Isolators

Dynamic Isotropy Design and Analysis of a Six-Dof Active Micro-Vibration Isolation Manipulator on Satellites

Analysis for the Principle of Whole-Spacecraft Vibration Isolation

Hybrid Optimization of a Vibration Isolation System Considering Layout of Structure and Locations of Components

Parameter design and experimental study of a bifunctional isolator for optical payload protection and stabilization

Design and test for the shock isolation structure of a whole spacecraft

Experimental Analysis on Performance and Damping Reliability of Whole-Spacecraft Vibration Isolators

Experimental Research on Whole-Spacecraft Vibration Suppression

A New Type Semi-Active Whole-Spacecraft Isolation Platform and Its Fuzzy Optimal Control

Novel Active–Passive Piezoelectric Hybrid Constrained-Layer Damping Technique for Vibration Isolation in a Whole Spacecraft

Study of Whole-Satellite Active Vibration Isolation Platform