Abstract:With the decrease of sheet thickness, the stiffness and buckling behavior of automobile body panel are more and more concerned. In this paper, the stiffness and buckling behavior of panels with stamping-induced imperfection is studied. Imperfections caused in drawing and springback are obtained by finite element analysis and introduced to define the initial state of the panel before indenting. The indenting procedure is simulated in ABAQUS Standard. In order to solve the buckling problem, a viscous pressure that is proportional to the relative velocity between surfaces is added artificially. For comparison, a simplified model in which imperfections are not considered is also established. Comparing the simulation results with the reference experiment, we find that the stamping-induced imperfections lead to a more severe oil canning phenomena under a buckling load, although they increase panel's initial stiffness a bit. Moreover, among all stamping-induced imperfections, the geometrical imperfection (surface deflection) is beneficial to increase panel's buckling load, and the material imperfections (residual stress and uneven thickness) help to decrease panel's buckling load and can make oil canning more severe during post-buckling. Influences of blank holder force, sheet thickness and material property on panel stiffness and buckling behavior are also studied. The work of this paper is beneficial to processing optimization, material selection, and reinforcement design for automotive exterior panels.

Determination of Strain Distribution and Forming Defects for Automobile Panel Stamped Parts

Forming Defects Analysis of Auto-Panel Stamped Part with Experimental Strain Approach

Analysis of the Forming Characteristics of Automobile Stamped Panel Parts Based on the Experimental Grid Method

Study on Simulation of Stamping Forming and Die Surface Optimization of Aluminum Alloy Plate

Numerical Simulation And Experimental Method For Auto-Panel Forming Defects Analysis

Analysis and Control of Car Door Inner Panel Forming Fracture Based on Experience Knowledge and Numerical Simulation

Study on the Forming Process Parameters of Automobile Front Panel Reinforcing Plate Using Orthogonal Experiment Method by Numerical Simulation Technology

Integrated Forming Process of Side-Frame Outer Panel

Dynamically Regulate and Control Complicated Auto Panel Uniform Forming

Study on the Effects of Forming Parameters on the Plastic Flow of Axisymmetrical Curved Parts in Stamping Process

The Stiffness and Buckling Behavior of Panels with Stamping-Induced Imperfections

Die Structure Analysis Of Stress Distribution During High-Strength Steel Stamping Process And Experimental Validation

Analysis of Cracking of Automotive Stamping Parts and Improvement Measure

Automotive Structure Performance Analysis Considering the Effect of Stamping History

Research on Integrated Formability Analytical Techniques for Automotive Panels

Investigation on Forming Process of Automobile Trunk Side Panel Based on Numerical Simulation Technology

Application of Forming Simulation of Automobile Covering Parts

Study on the influence factors for surface low of exterior auto-panels

Study on the drawbead setting of the large deformation area in a trunk lid

Numerical and Experimental Investigation into Hot Stamping of High Strength Steel Sheet for Auto B Pillar Reinforced Panel

Study on influence of deformation degree on the stiffness of automotive shallow shells