Abstract:Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, Ahead of Print. The sealing performance is a critical characteristic of the stop valve used in an 11000-m manned submersible, while it is a challenge when the pressure difference at the valve port reaches 120 MPa. Previous studies have mainly focused on the effect of surface microtopography, such as the surface roughness, on sealing performance. They believed that rougher surfaces will result in more severe leaks. However, in the sealing experiments of two stop valves with different materials and surface roughness in this paper, the relationship between surface roughness and sealing performance is inconsistent with existing research. There should be another factor that affects the sealing performance of the stop valves more strongly. So a new sealing principle considering the roundness error is proposed. The sealing force, which is determined by the environmental pressure, creates radial deformation on the valve port. The radial deformation of the valve seat is analyzed by a validated finite element analysis (FEA) at various environmental pressures. Then the critical environmental pressure at which the leak stops is obtained when the radial deformation is greater than the roundness error, which is measured. The results show that the critical environmental pressure obtained by FEA is very close to that obtained by experiment. So the consideration of the roundness error of the valve seat is accurate and helpful to the research on the sealing performance of the ultra-high pressure stop valves, and the sealing performance of the ultra-high pressure stop valve can be easily evaluated by FEA.

Design of High Pressure Assembled Mechanical Seal Used in Submarine

A Deep-Sea Large-Volume High-Pressure Simulation System—design, Analysis and Experimental Verification

Sealing Performance Analysis of Deep-Sea Sediment Sampler

Failure Analysis and Improvement of Mechanical Seals in Underwater Turbine

Experimental Study on Dynamic Sealing Performance under High Pressure and High Speed

Analysis and Experimental Research on Efficiency Characteristics of a Deep-Sea Hydraulic Power Source

Experimental Research and Finite Element Analysis of Seals in the Pressure Compensator

Design and Performance Analysis of a Pressure Chamber for Simulation of Deep Sea Conditions

Sealing Performance of Adaptive Contacting Mechanical Seal

Design of High-speed Pump Mechanical Seal of Acetic Anhydride Production Line

Sealing Characteristics Analysis of New Subsea Wellhead Sealing Device

Analysis on Self-compressibility of Sealing Materials under High Pressure in Deep-sea

Development of Mechanical Seal for Containment Spray Pump of PWR Nuclear Power Plant

Sealing performance of sealing structure in a sediment sampler under ultra-high pressure

Research and Development of a Rubber O-Ring Sealing Device for High Pressure Vessels

Design and Experimental Research on Bidirectional Sealing Structure for Deep-sea High Pressure Valve

Research on the sealing performance of a seawater stop valve considering roundness error used in an 11000-m manned submersible

Dynamic failure analysis of static seals under pressure fluctuation in an ultrahigh-pressure water piston pump

Engineering Development and Application of Hydrodynamic Mechanical Seal of Reactor Coolant Pump

Fluid-solid Strong-Interaction Model of Mechanical Seals in Reactor Coolant Pumps

Design and Simulation Analysis of a 120 MPa Deep-Sea Ultra-High Pressure Environment Simulation Test Chamber