Design and calibration of MIMU based on chip size micro inertial sensors
Yun Xu,Xinhua Zhu,Yu Wang
DOI: https://doi.org/10.4028/www.scientific.net/AMR.849.302
2014-01-01
Advanced Materials Research
Abstract:With rapid development of micro fabrication technology, the performance of MIMU has gradually improved. The MIMU introduced in this paper is based on the silicon micro machined gyroscope of type MSG7000D and accelerometer of type MSA6000. The volume of it is 3x3x3cm(3), the mass is 68.5g and the power consumption is less than 1w. The experimental result shows that the bias stability of the gyroscope and accelerometer for each axis of the designed MIMU is less than 10 degrees/h and 0.5mg respectively. For the non orthogonality in three axes of the structure, MIMU needs to be calibrated. After calibration, the measurement accuracy has improved by an order of magnitude. The designed MIMU can satisfy the requirement of high performance, low cost, light weight and small size for strap-down navigation system, thus it can be widely applied not only to the field of vehicles integrated navigation, attitude measurement but also to the fields of personal goods such as mobile, game consoles and so on.